Gebruiksaanwijzing /service van het product S 4212 van de fabrikant Miele
Ga naar pagina of 36
Operating instructions Vacuum cleaners S 4000 Series To avoid the risk of accidents or damage to the appliance, it is essential to read these instructions before using it for the first time.
Caring for the environment Description of the appliance Warning and Safety instructions Preparing for use Using the accessories supplied Use Mains cable . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Disposal of packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal and can normally be recycled. Ensure that any plastic, wrappings, bags etc. are disposed of safely and kept out of the reach of babies and young children.
The illustration shows the maximum number of features available on these Miele vacuum cleaners. Certain models are supplied as standard with the following accessories which are not illustrated on this page.
a Handle (some models have an air inlet valve in the handle) * b Suction power selector + / -* c Stand-by button for pauses in vacuuming * d LED * e Release button f Accessories holder g Release butto.
This vacuum cleaner meets statutory safety requirements. Improper use can, however, lead to personal injury and material damage. To avoid the risk of accidents and damage to the vacuum cleaner, read these instructions carefully before using it for the first time.
Technical safety ~ Ensure that the connection data on the data plate (voltage and frequency) match the mains electricity supply. It is essential that they match to avoid damage to the appliance. ~ The plug must be fitted with a 13 A fuse (UK). ~ Before using the vacuum cleaner, check for any signs of damage.
Correct use ~ To avoid the risk of damage, do not use the vacuum cleaner without the dustbag, dust compartment filter and exhaust filter in place. Otherwise it could get damaged. ~ If a dustbag is not inserted, the dust compartment cover does not normally close.
Accessories Miele accessories including floorheads, filters and dustbags are available to order from your Miele retailer, the Miele Spare Parts Department or via the internet on www.miele-shop.com. ~ To avoid the risk of injury when vacuuming with a Miele Electrobrush or Turbobrush, do not touch the rotating roller brush.
Attaching the suction hose ^ Insert the hose connector into the socket until it clicks into position. To do this, line up the guides on the two pieces. To remove the suction hose from the cleaner ^ Press the release buttons at the side of the hose connector, and lift the hose from the socket.
Your vacuum cleaner is fitted with one of the following types of suction tube, depending on the model: – 2-part telescopic tube – Triscopic telescopic tube Adjusting the telescopic suction tube One part of this telescopic tube is packed inside the other and can be adjusted to suit your height for comfortable vacuum cleaning.
Fitting the standard floorhead ^ Push the suction tube into the floorhead and turn it clockwise or anti-clockwise until it clicks into position. ^ To release the floorhead from the suction tube, press the locking button (see arrow) and pull the suction tube away from the floorhead.
The following accessories are supplied: a Dusting brush b Upholstery nozzle c Crevice nozzle d Accessory holder for the above accessories Symbols on the holder show where to attach the different accessories. Crevice nozzle For cleaning in folds, crevices or corners.
Upholstery nozzle For cleaning upholstery, mattresses, cushions, curtains, covers etc. Accessories holder ^ Attach the accessories holder to the suction tube. Floorhead For general use and also for vacuuming the stairs. For safety reasons when vacuuming stairs it is best to start at the bottom of the stairs and move upwards.
Mains cable Unwinding the cable ^ Pull out the mains cable to the required length (max. approx. 5.5 m). Warning: If vacuuming for longer than 30 minutes, the mains cable must be pulled out to its fullest extent. Otherwise there is a danger of overheating and damage.
Models with radio controls Certain models have controls on the handle which transmit radio signals to the vacuum cleaner. The stand-by indicator on the vacuum cleaner will light up when the vacuum cleaner is ready to use. To pause the appliance during operation: ^ Press the stand-by button on the handle.
Vacuuming ^ When vacuuming, pull the cleaner behind you on its wheels. You can stand it upright for vacuuming stairs and curtains etc. Warning: When vacuuming especially fine dust, e.g. sawdust, sand, plaster, flour, talcum powder etc., electrostatic charges build up naturally.
Rotary selector ^ Turn the suction power selector manually to the suction power setting you require. + / - foot controls Press the controls to select the suction power you require. ^ Press the + control to select a higher setting. ^ Press the - control to select a lower setting.
Opening the air inlet valve (not on models with radio-controls on the handle) It is easy to reduce the suction power for a short time, e.g. to prevent rugs or other objects being sucked into the vacuum cleaner. ^ Open the air inlet valve far enough to reduce the suction power.
Parking system A parking system has been designed for conveniently parking the vacuum cleaner during pauses. ^ Slot the floorhead into the parking attachment at the back of the vacuum cleaner. Transportation and storage ^ Stand the vacuum cleaner upright when it is not being used and during storage.
Warning: Always disconnect the vacuum cleaner from the electrical supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug.
When to change the dustbag Change the dustbag when the colour marker in the dustbag change indicator fills the display, or sooner if it is no longer effective (see possible reasons for this below). Dustbags are designed for single use only. Do not attempt to re-use them as suction would be reduced.
Replacing the dustbag ^ Press the release button for the dust compartment lid and raise the lid as far as it will go. The dustbag has a closing flap which closes automatically when the dust compartment lid is raised to prevent any dust escaping. ^ Pull the dustbag out by the grip next to the self-closing flap on the collar.
When to change the exhaust filter Depending on the model, your vacuum cleaner will be fitted as standard with one of the following exhaust filters: a Air Clean filter SF-AC 30, Replace this filter every time you start a new packet of Miele dustbags.
Replacing the Air Clean filter Do not use more than one exhaust filter at a time. ^ Open the dust compartment lid. ^ Release the filter grille and raise it upwards. Grasp the used Air Clean filter by the clean, unsoiled section (see arrow) and take it out.
Replacing the Active Air Clean or Active HEPA filter Do not use more than one exhaust filter at a time. ^ Open the dust compartment lid. ^ Remove the exhaust filter.
Replacing one type of filter with another Depending on the model, your vacuum cleaner will be fitted as standard with one of the following exhaust filters: a Air Clean filter SF-AC 30, b Active Air Clean SF-AAC 50 (black) c Active HEPA SF-AH 50 (blue) Please note 1.
When to change the dust compartment filter (for motor protection) Replace this filter every time you start a new packet of dustbags. A dust compartment filter is supplied with every packet of Miele dustbags. How to change the dust compartment filter ^ Open the dust compartment lid.
When to change the battery in the radio-operated handle Approx. every 18 months. One 3 V battery (CR 2032) is required. The vacuum cleaner can still be used when the battery has run out or if there is no battery fitted. ^ Switch the vacuum cleaner on using the On/Off foot control s .
When to change the thread lifters The thread lifters on the suction inlet to the floorhead and upholstery nozzle can be replaced. Check them from time to time and replace them if the pile has worn down. To replace the thread lifters ^ Use a knife or similar object to remove them from the slots.
Warning: Always disconnect the vacuum cleaner from the electricity supply for maintenance work and for cleaning. Switch off at the wall socket and remove the plug.
The vacuum cleaner switches off automatically. On certain models, the overheating warning light also comes on. A temperature limiter switches the vacuum cleaner off automatically if it gets too hot. Some models also have a warning light , which comes on to indicate that it has overheated.
Miele accessories including floorheads, filters and dustbags are available to order from your Miele retailer, Miele or via the internet at: Certain models are supplied as standard with one or more of .
Hand-held mini Turbobrush For cleaning upholstery, mattresses, car seats etc. Universal brush For dusting books, shelves, etc. Dusting brush with natural bristles This brush is suitable for particularly delicate objects. Radiator brush For cleaning radiators, narrow shelves and crevices.
All electrical work should be carried out by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). The voltage and connected load are given on the data plate located underneath the vacuum cleaner.
Alteration rights reserved / (S4212- S4782) - 3009 M.-Nr. 07 345 550 / 02.
Een belangrijk punt na aankoop van elk apparaat Miele S 4212 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Miele S 4212 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Miele S 4212 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Miele S 4212 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Miele S 4212 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Miele S 4212 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Miele S 4212 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Miele S 4212 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
