Gebruiksaanwijzing /service van het product PS-M03 van de fabrikant Oregon Scientific
Ga naar pagina of 28
Full Weather Station with Radio Controlled Clock and AM / FM Radio (Model #: PS-M03 / PS-M03U) User Manual PS M03 English Cover 6/30/03, 11:11 PM 1.
EN 1 TABLE OF CONTENTS About this guide ......................................................... 2 Product overview ........................................................ 3 Getting started ...........................................................
EN 2 ABOUT THIS GUIDE Congratulations on your selection of the Philippe Starck with Oregon Scientific Full Weather Station with Radio Controlled Clock and AM / FM Radio (PS-M03 / PS-M03U).
EN 3 PRODUCT OVERVIEW TOP AND BATTERY COMPARTMENT VIEW DESCRIPTIONS 1. Snooze / Light button ( 12, 19) 2. Light sensor ( 19) 2 1 PS M03 English R18 7/16/03, 1:04 PM 3.
EN 4 BOTTOM AND SIDE VIEW DESCRIPTIONS 1. Battery compartment ( 8) 2. Backlight switch ( 19) 3. Reset button ( 8, 20) 4. Light sensitivity knob ( 19) 5. Headphone jack ( 18) 6. DC input jack ( 8) 7. Antenna ( 17) AC power adapter not shown. NOTE RESET SENSOR ON LIGHT OFF AUTO LIGHT DC 7.
EN 5 LCD DISPLAY DESCRIPTIONS 1. Low battery icon ( 8) 2. Clock ( 10) 3. Barometer ( 13) 4. Weather forecast ( 14) 5. Moon phase ( 13) 6. Calendar ( 12) 7.
EN 6 BACK VIEW BUTTON DESCRIPTIONS 1. Select - switch modes / change settings ( 8, 9) 2. Up - increase setting / activate auto-synch ( 10) 3. Down - decrease setting / deactivate auto-synch ( 10) 4. Alarm -activate / deactivate alarm ( 12) 5. Channel - switch remote unit ( 15) 6.
EN 7 REMOTE UNIT DESCRIPTIONS 1. Temperature / Trend display ( 15, 17) 2. Low battery icon ( 8) 3. Humidity / Trend / Comfort Level display ( 15, 16, 17) 4. ° C/ ° F switch ( 9) 5. Channel switch ( 9) 6. Reset button ( 8, 20) 7. Battery compartment ( 8) 8.
EN 8 GETTING STARTED BATTERIES Batteries for the remote and main units are supplied with this product. Replace them whenever the low battery signal ( ) displays. Remove the battery compartment lid on the bottom of the main unit, and insert the batteries.
EN 9 CHANGE SETTINGS Press and hold SELECT for 2 seconds. Then, press UP or DOWN to change each setting. Press SELECT to switch options. REMOTE UNIT SET UP Up to 3 remote units can be used with this product to monitor outdoor temperature and humidity.
EN 10 CLOCK This product can automatically synchronize the date and time with official time-keeping organizations in Frankfurt, Germany (PS-M03) or Rugby, England (PS-M03U). When the unit is within 1500 km (932 miles) of a RF signal, the reception icon will blink during reception.
EN 11 SET OR CHANGE THE CLOCK 1. Press SELECT to switch to the Clock Mode. The time will flash. 2. Press and hold SELECT for 2 seconds to enter the setting mode. 3. Select the 12/24-hour format, hour, and minute. Press UP or DOWN to change the setting.
EN 12 If you choose , use the radio control buttons to select the AM/FM band, radio station and volume level ( 18) . 4. Press SELECT again when you are finished. SNOOZE Press the SNOOZE/LIGHT button the top of the unit to temporarily disable the alarm for 8 minutes.
EN 13 MOON PHASE Press SELECT until the Calendar Area flashes. Then, press UP or DOWN to change the date and view the corresponding moon phase. BAROMETER This product tracks barometric pressure changes over the past 24 hours to provide the weather forecast ( 14) and a trend line showing the direction of barometric change.
EN 14 WEATHER FORECAST This product forecasts the next 12 to 24 hours of weather within a 30 to 50 km (19 - 31 mile) radius with 70 to 75 percent accuracy. The weather forecast is always displayed. VIEW THE LAST 24 HOURS Press SELECT 2 times until the Barometer Area flashes.
EN 15 CLEAR MIN / MAX RECORDS While viewing Min/Max records, press and hold UP or DOWN for 2 seconds until a beep sounds. This clears the previous measurements from the memory.
EN 16 SENSOR SEARCHING If there is no remote unit signal, the temperature and humidity measurements will be blank. Check the remote unit batteries, or press and hold UP and DOWN for 2 seconds to search for the remote unit(s).
EN 17 SET UNIT While in Temperature / Humidity Mode, press SELECT for 2 seconds. Press UP or DOWN to switch between ° C and ° F. Press SELECT to confirm. RADIO You can listen to Phase Lock Loop (PLL) digital radio broadcasts with this product. ANTENNA The antenna wire is located on the side of the unit.
EN 18 VOLUME Press UP or DOWN . There are 8 volume levels. SWITCH AM/FM BAND Press TUNING to enable auto tuning. Press again to switch AM/FM band. SELECT STATION Press STATION . There are 16 preset channels: 8 for FM and 8 for AM. TUNING Press TUNING .
EN 19 3. The Light sensitivity knob is located in the battery compartment. Rotate to adjust. 4. When activated, the continuous backlight will be half as bright as usual. To achieve full brightness, press SNOOZE/LIGHT. BACKLIGHT Press SNOOZE/LIGHT to illuminate the backlight for 5 seconds.
EN 20 WARNINGS This product is designed to give you years of service if handled properly. Observe the following guidelines: • Never immerse the unit in water. This can cause electrical shock and damage the unit. • Do not subject the main unit to extreme force, shock, or fluctuations in temperature or humidity.
EN 21 • Do not make any changes or modifications to this product. Unauthorized changes may void your right to use the product. • The contents of this user guide are subject to change without notice. • Images not drawn to scale. TROUBLESHOOTING Check here before contacting our customer service department.
EN 22 Radio Problem Symptom Remedy Select radio format ( 10) Reception is poor / static Place clock near a window ( 10) Remote unit Cannot locate remote unit Check batteries ( 8) Check location ( 9) Disable auto- synchronization ( 10) Cannot change clock Adjust the antenna ( 17) Problem Symptom Remedy Clock Cannot auto-synchronize 1.
EN 23 Problem Symptom Remedy Temp Shows “LLL” or “HHH” Temperature is out-of- range. Cannot change channel Check sensors. Only one sensor is working ( 15) SPECIFICATIONS Dimensions: L x W x H 129 x 43 x 133.3 mm (5.1 x 1.7 x 5.3 inches) Weight 525 grams with batteries Remote unit dimensions L x W x H 75 x 35 x 78.
EN 24 Barometer Unit mb/hPa or inHg Range 500 to 1050 mb (14.77 to 31.01 inHg) Resolution 1 mb (0.03 inHg) Altitude -100 to 2500 meters (-328 to 8202 feet) Display Rainy, cloudy, partly cloudy, sunny .
EN 25 Channel No. 1, 2, or 3 Unit ° C or ° F Radio-controlled clock Synchronization Auto or disabled Clock display HH:MM:SS Hour format 12hr AM/PM (MSF format) 24hr (DCF format) Calendar DD/MMM; wee.
EN 26 ADDITIONAL RESOURCES Visit our website (www.oregonscientific.com) to learn more about your new product and other Oregon Scientific products such as digital cameras, hand-held organizers, health and fitness gear, and weather stations.
EN 27 EC-DECLARATION OF CONFORMITY This product contains the approved transmitter module TX 07 and complies with the essential requirements of Article 3 of the R&TTE 1999/5/EC Directives, if used for its intended use and that the following standard(s) has/have been applied: Radio frequency spectrum (Article 3.
Een belangrijk punt na aankoop van elk apparaat Oregon Scientific PS-M03 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Oregon Scientific PS-M03 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Oregon Scientific PS-M03 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Oregon Scientific PS-M03 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Oregon Scientific PS-M03 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Oregon Scientific PS-M03 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Oregon Scientific PS-M03 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Oregon Scientific PS-M03 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
