Gebruiksaanwijzing /service van het product 4300 WOOD STOVE SERIES van de fabrikant Quadra-Fire
Ga naar pagina of 32
4300 WOOD ST OVE SERIES Advanced Combustion T echnology (ACT) 1445 North Highway Colville, W A 991 14 SA VE THESE INSTRUCTIONS Part 250-7061C December 10, 2004 www .quadrafire.com PRIOR TO FIRST FIRE : Remove all labels from glass. Clean plated surfaces with a glass cleanser and soft cloth to prevent staining from fingerprint oils.
4300 ACT Wood Stove Series Page 2 250-7061C December 10, 2004 R ___________________________ Alan T rusler Senior Vice President Dealer Channel ___________________________ Dan Henr y Vice President Res.
Page 3 250-7061C December 10, 2004 4300 ACT Wood Stove Series R MODEL NAME Uni-Body: ___Step T op ___ Millennium Serial Number Date Purchased Dealership Where Purchased Dealer Phone Additional Information: After completing your warranty card, attach your sales receipt and warranty stub here for future reference.
4300 ACT Wood Stove Series Page 4 250-7061C December 10, 2004 R LISTINGS & SAFETY CAUTIONS These installation instructions describe the installation and operation of the QUADRA-FIRE 4300 woodstove. This stove meets the U.S. Environmental Protection Agency’s 1990 particulate emission standards.
Page 5 250-7061C December 10, 2004 4300 ACT Wood Stove Series R DIMENSIONS 26-1/2" (673mm) 34-1/4" (870mm) 10-1/2" (267mm) 15.0" (381mm) 4-3/16" (106mm) 25-3/16" (640mm) 4300 STEP TOP UNI-BODY PEDEST AL MODEL 4300 STEP TOP UNI-BODY LEG MODEL 26-1/2" (673mm) 34-1/4" (870mm) 10-1/2" (267mm) 15.
4300 ACT Wood Stove Series Page 6 250-7061C December 10, 2004 R DIMENSIONS 4300 MILLENNIUM MODEL C L 21.0" (533mm) 14-15/16" (379mm) 10-15/16" (278mm) 10-3/16" (259mm) 18.
Page 7 250-7061C December 10, 2004 4300 ACT Wood Stove Series R G H * 90° OFF TOP UP & OUT CEILING CLEARANCE STOVE TO CEILING CLEARANCE CLEARANCES TO COMBUSTIBLES (UL AND ULC) A B C D BACKW ALL /.
4300 ACT Wood Stove Series Page 8 250-7061C December 10, 2004 R FLOOR PROTECTION: Floor protector must be noncombustible material, extending beneath heater and to the front/sides/rear as indicated. The floor must be non-combustible or otherwise adequately protected from radiant heat given off by the unit and from sparks and falling embers.
Page 9 250-7061C December 10, 2004 4300 ACT Wood Stove Series R R = x T 1 k R = x T 1 K x 12 k-factor is given with a required thickness (T) in inches: K-factor is given with a required thickness (T) in inches: r-factor is given with a required thickness (T) in inches: R = r x T R-value given - no conversion needed.
4300 ACT Wood Stove Series Page 10 250-7061C December 10, 2004 R T o be sure that your Quadra-Fire stove burns properly , the chimney draft (static pressure) should be approximately -.
Page 1 1 250-7061C December 10, 2004 4300 ACT Wood Stove Series R There are two separate and different parts to a flue system: the chimney connector and the chimney itself. A. Single wall connector or stove pipe. This must be at least 24 gauge mild steel or 26 gauge blue steel.
4300 ACT Wood Stove Series Page 12 250-7061C December 10, 2004 R FIGURE 12B SOLID P ACK CHIMNEY WITH MET AL SUPPORTS AS A THIMBLE For the method of installation to a masonry chimney shown in Figures 1.
Page 13 250-7061C December 10, 2004 4300 ACT Wood Stove Series R First, make the frame for the thimble, ensur- ing it is no smaller than 14" (356mm) square, to maintain a 2" (51mm) air space around the chimney section. Attach the wall spacer to the chimney side of the frame.
4300 ACT Wood Stove Series Page 14 250-7061C December 10, 2004 R * * Floor Protector Chimney Connector Combustible Ceiling Combustible Wa ll Insulated " T " Flashing Listed Ca p Maintain 2&q.
Page 15 250-7061C December 10, 2004 4300 ACT Wood Stove Series R Spark Arestor Cap Roof Flashing Storm Colla r Joist Shield/Firestop Double wal l connector pipe Floor Protector Outside Air Floor V ent Outside Air Rear V ent 1. An outside air inlet must be provided for combustion and must remain clear of leaves, debris, ice and/or snow .
4300 ACT Wood Stove Series Page 16 250-7061C December 10, 2004 R 1. Place protective pad or stove pallet on floor . 2. Lay body of stove on its back on protective pad or pallet. 3. Remove ash removal system top and bottom cover plates by loosening nuts under stove.
Page 17 250-7061C December 10, 2004 4300 ACT Wood Stove Series R PEDEST AL MODEL 1 Place protective pad or stove pallet on floor . 2. Lay body of stove on its back on protective pad or pallet. 3. Loosen screws on adapter and slide pedestal over adapter on bottom of stove 4 .
4300 ACT Wood Stove Series Page 18 250-7061C December 10, 2004 R BLOWER SPEED CONTROL Blower Mounting Flange Outer Skin INST ALLA TION OF OPTIONAL BLOWER, Part 831-1701 The blower is shipped fully assembled and ready for installation. N OTE: When th e s peed control is tu rned clockwi se, it will c lick on to hi gh speed.
Page 19 250-7061C December 10, 2004 4300 ACT Wood Stove Series R (Cut-away view) FRONT COVER SIDE COVER (2) 4" (102mm) FLEX LINE (Not Included) FLEX FLANGE OUTSIDE AIR TERMINA TION CAP (contains .
4300 ACT Wood Stove Series Page 20 250-7061C December 10, 2004 R ST ART -UP AIR CONTROL PRIMARY AIR CONTROL BURNING PROCESS I n recent years there has been an increasing concern about air quality . Much of the blame for poor air quality has been placed on the burning of wood for home heating.
Page 21 250-7061C December 10, 2004 4300 ACT Wood Stove Series R NOTE: These are approximate settings, and will vary with type of wood or chimney draft. Due to altitude and other environmental circumstances, this operation information is a guideline only .
4300 ACT Wood Stove Series Page 22 250-7061C December 10, 2004 R OP ACITY This is the measure of how cleanly your stove is burning. Opacity is measured in percent; 100% opacity is when an object is totally obscured by the smoke column from a chimney , and 0% opacity means that no smoke column can be seen.
Page 23 250-7061C December 10, 2004 4300 ACT Wood Stove Series R MAINTENANCE and GLASS CARE DISPOSAL OF ASHES Ashes should be placed in a metal container with a tight fitting lid. The closed container of ashes should be placed on a noncombustible floor or on the ground, well away from all combustible materials, pending final disposal.
4300 ACT Wood Stove Series Page 24 250-7061C December 10, 2004 R 1 1 3 1 1 3 1 1 1 1 1 1 1 1 4 2 2 3 3 1 1 BRICK REPLACEMENT INSTRUCTIONS The Step -T op Model accep ts the Ash Remov al Syste m, and the brick pattern incorporates the ash grate. 1. After the coals have completely cooled, remove all old brick and ash from unit and vacuum out firebox.
Page 25 250-7061C December 10, 2004 4300 ACT Wood Stove Series R FIGURE 25C - Baffle and Ceramic Blanket . Fiberboard Baffle Ceramic Blanket Allen wrench on retainer bolt First tube has larger holes FIGURE 25B - Allen wrench on retainer bolt. DOOR HANDLE ASSEMBL Y 1.
4300 ACT Wood Stove Series Page 26 250-7061C December 10, 2004 R 17.0" (432mm) 19.0" (483mm) Ceramic Blanket 1 2 3 4 5 6 7 8 9 10 1 1 12 Item Part Name 1 Air Control Rods 2 Ash Removal Grate.
Page 27 250-7061C December 10, 2004 4300 ACT Wood Stove Series R 831-1671 . . . . . . . .Ash Removal System (ARS) 831-1701 . . . . . . . .Blower Assembly 832-1092 . . . . . . . .Door Assembly , Black 832-1912 . . . . . . . .Door Assembly , Gold T rim DR-31/43NL .
4300 ACT Wood Stove Series Page 28 250-7061C December 10, 2004 R NOTES.
Page 29 250-7061C December 10, 2004 4300 ACT Wood Stove Series R NOTES.
4300 ACT Wood Stove Series Page 30 250-7061C December 10, 2004 R Date of Service Performed By Description of Service Service and Maintenance Log.
Page 31 250-7061C December 10, 2004 4300 ACT Wood Stove Series R LIMITED LIFETIME W ARRANTY The Hearth & Home T echnologies limited Lifetime Warranty guarantees that the following components will work as designed for the lifetime of the stove or Hearth & Home T echnologies will repair or replace them.
250-7061C December 10, 2004 Page 32 R A TTENTION INST ALLERS: PLEASE RETURN THESE INSTRUCTIONS T O THE HOME OWNER WHEN THE INST ALLA TION IS COMPLETE This product may be covered by one or more of the .
Een belangrijk punt na aankoop van elk apparaat Quadra-Fire 4300 WOOD STOVE SERIES (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Quadra-Fire 4300 WOOD STOVE SERIES heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Quadra-Fire 4300 WOOD STOVE SERIES vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Quadra-Fire 4300 WOOD STOVE SERIES leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Quadra-Fire 4300 WOOD STOVE SERIES krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Quadra-Fire 4300 WOOD STOVE SERIES bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Quadra-Fire 4300 WOOD STOVE SERIES kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Quadra-Fire 4300 WOOD STOVE SERIES . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
