Gebruiksaanwijzing /service van het product DRG-40 van de fabrikant Bakers Pride Oven
Ga naar pagina of 40
Gas Rotisserie Oven MODEL DRG-40 Installation and Operation Manual Serial Numbers 120170 and Higher.
Warranty Information LIMITED ONE YEAR WARRANTY BKI (The "Company") warrants to the origin al purc haser that at time of shipment from the Company factory, this equipment will be free from defect in materials and workmanship.
Gas Rotisserie Oven Table of Contents 1 T able of Content s Table of Contents .............................................................................................................. ...................................... 1 Introduc tion .......
Gas Rotisserie Oven Introduction 2 Introduction Your DRG-40 is a computer cont rolle d gas fired rotisse rie oven. It utilizes a double revolving rotor system to ensure even product cooking. The unit contains a single stage coo k and hold computer with 5 custo miza ble cook programs.
Gas Rotisserie Oven Introduction 3 Safe Work Practices Wear Safe Clothing Appropriate To Your Job Always wear your insulated mitts when handling hot racks or touching any hot metal surface. If you lose or damage your mitts, you can b u y new ones at your local restaurant equipment supply store or from your local BKI Distribut or.
Gas Rotisserie Oven Introduction 4 Keep Safety Labels Clean and in Good Condition Do not remove or cover any safety labels on your e quipment. Keep all safety labels clean and in good conditio n. Replace any damaged or missing safety labels. Refer to the Safety Labels section for illustration and location of safety labels on this unit.
Gas Rotisserie Oven Introduction 5 Do Not Smoke Near The Oven This oven uses combustible fuels to operate. Smokin g near this oven could possibly cause a fire.
Gas Rotisserie Oven Introduction 6 Safety Labels.
Gas Rotisserie Oven Introduction 7.
Gas Rotisserie Oven Operation 8 Operation Controls and Indicators Refer to the figure and table below for a n expl anatio n of the oven’s controls and indicators.
Gas Rotisserie Oven Operation 9 Item # Description Function 1 HEAT ON LED Illuminates to indicate that the top burners are on. It cuts off only when the temperature is reached. 2 TIME/TEMP Display Shows time/temperature and other messages d uring operation.
Gas Rotisserie Oven Operation 10 Controller Operation The DRG-40 contains a sin gle-stage cook and hold timer /temperature controller that has 5 co ok programs and 5 modes of operation. This section explain s the ope ratin g modes and programm ing of the controller.
Gas Rotisserie Oven Operation 11 If a cycle is changed during a timed cook or hol d cycl e and t he time is set for a value that is less than the elapsed time for the current cycle, the cycle will be com pleted when the review mode is exited.
Gas Rotisserie Oven Operation 12 Cooking 1. Place the POWER switch, LIGHTS switch, and ROTOR switch located on the front panel in t he “ON” position. The controller will automatically load the settings from the last program selecte d and b egin regulating to the cook or hold te mperature.
Gas Rotisserie Oven Operation 13 Probe (Thermocouple) Diagnostics If the probe (therm ocouple inside the oven) stops working, the cont roller will cancel the cooking cycle, an audible alert will sound, and the display will show “ PROB ”.
Gas Rotisserie Oven Installation 14 Inst allation Inspection for Shipping Damage It is the owners’ responsibility to file all freight claims with the delivering truck lin e.
Gas Rotisserie Oven Installation 15 • Make sure a restraining de vice is used that complies with the Standard for Commercial Gas Ranges, ANSI Z83.11/CGA 1.8 (such as BKI part number FT02 79) to guard against transmissi on of strain to the connecto r.
Gas Rotisserie Oven Installation 16 If you are unable to do this, drill a small ¼” hole throu gh the ba ck flange of the shelf, then follow the restraining device ma n ufacturer instru ctions to finish the installation. Use appliance connectors and quick-di sconnect dev ices that are in compliance with the applicable ANSI and CSA standard s.
Gas Rotisserie Oven Maintenance 17 Maintenance The restraining device must always be c onnected when the appliance i s in service. Disconnect for movement, such a s servicing or cleaning. Re con nect the restraint when oven has been returned to its normal po sition.
Gas Rotisserie Oven Maintenance 18 2. Turn off all switches and controls and let the oven cool. 3. Drain and dispose of the re ndering s from bottom of oven. 4. Remove all food products from the unit. Remove V-sp its, meat baskets and meat forks from the unit and place them in a large sink to soa k in hot clea ning solution ( BKI Cleaner).
Gas Rotisserie Oven Maintenance 19 B C • Place the rotor shaft in a large sink..
Gas Rotisserie Oven Maintenance 20 • If using a dual rotor shaft, loosen the center spinner hub. Remove the center rotor from the shaft and pla ce in l arge sink.
Gas Rotisserie Oven Maintenance 21 • Pull drive rotor away from the oven wall to dise ngage drive hub (on rotor) from the drive shaft and place in sink.
Gas Rotisserie Oven Maintenance 22 • Pull passive rotor away from the oven wall to dise ngage drive hub (on rotor) fro m the drive shaft and place in sink.
Gas Rotisserie Oven Maintenance 23 6. Place the Rotor System components in a large sin k to soak in hot cleaning solution. Clea n the rotors with warm water, a sponge and BKI Cleane r.
Gas Rotisserie Oven Maintenance 24 Troubleshooting Problem Cause Possible Solution Unit will not turn on. Power to unit is not on. Problem with building power panel, circuit breaker or fuse. Check circuit breake r or fu ses at building power panel. Power cord may not be plugged into outlet.
Gas Rotisserie Oven Appendix A 25 Appendix A Gas Control Valve Instructions.
® U.S. Regi stered T rademar k Copyright © 1999 Honeywe ll Inc. • All Rights Reserved INSTALLATION INSTRUCTIONS 69-1226-2 VR8105, VR8205, and VR8305 Direct Ignition Combination Gas Controls APPLICATION These direct ig nition gas controls a re used in gas -fired applian ces with up to 415 ft 3 /hr .
VR8105, VR8205, AND VR8305 DI RECT IGNITION COMBINATION GAS CONTROLS 69-1226—2 2 SPECIFICATIONS Body Patter n: S traight through; se e T able 1 for inlet and outlet size. Electrical Ratin gs: V oltage and Frequency: 24 Vac, 60 Hz. Current Draw: 0.5A wit h both o perators energiz ed.
VR8105, VR8205, AND VR8305 DIRECT IGNITION COM BINATION GAS CONTROLS 3 69-1226—2 T able 6 shows additiona l specifications for th e CE-only models. T able 6. VR8205A,H/VR830 5A,H CE Models. CAUTION Equipment Damag e Hazard. Improper use c an damage equip ment.
VR8105, VR8205, AND VR8305 DI RECT IGNITION COMBINATION GAS CONTROLS 69-1226—2 4 CAUTION Equipment Damage. Can burn out val ve coil termina ls. Never apply a ju mper across (o r short) the valve coil te rminals , even t emporari ly . Follow th e applian ce manufact urers inst ructions i f available; otherwise use these instructio ns as a guide.
VR8105, VR8205, AND VR8305 DIRECT IGNITION COM BINATION GAS CONTROLS 5 69-1226—2 Complete the instr uctions below for installing the piping, inst alling th e control , connect ing the pi lot gas tubi ng and the wiring.
VR8105, VR8205, AND VR8305 DI RECT IGNITION COMBINATION GAS CONTROLS 69-1226—2 6 Fig. 5. Proper u se of wrench on ga s control with a nd without fl anges. Fig. 6. T op view of ga s control. Wiring Follow the wiring instructions furnishe d by the appliance manufact urer , if availa ble, or u se the ge neral in structi ons provided below.
VR8105, VR8205, AND VR8305 DIRECT IGNITION COM BINATION GAS CONTROLS 7 69-1226—2 Fig. 7. T ypical wiring conn ections f or 24 volt control in S87 Direct Ignition System. Fig. 8. T ypical wiring co nnections w ith 24 vo lt control in S89 Direct Ignition System.
VR8105, VR8205, AND VR8305 DI RECT IGNITION COMBINATION GAS CONTROLS 69-1226—2 8 Check and Adjust Gas Input and Burner Ignition IMPORTANT 1. Do not exceed input rating stampe d on applianc e nameplat e, or manuf acturer’s recommend ed burner orifice pr essure fo r size orifice( s) used.
VR8105, VR8205, AND VR8305 DIRECT IGNITION COM BINATION GAS CONTROLS 9 69-1226—2 4. With main bur ner operating, c heck the gas contr ol flow rate us ing the mete r clocking met hod or check pressure using a manometer connected to the outlet pressur e tap on the gas contr ol.
VR8105, VR8205, AND VR8305 DI RECT IGNITION COMBINATION GAS CONTROLS 69-1226—2 1 0 T able 9. Pressure Regulator Specifica tion Pressure s (kPa). a Low Fire settin g range for VR830 5Q 1/2 in. by 1/2 in . and 1/2 in. by 3 /4 in. is 0.37 to 0.7 5 kPa.
VR8105, VR8205, AND VR8305 DIRECT IGNITION COM BINATION GAS CONTROLS 1 1 69-1 226—2 CAUTION Equipment Damage. Can burn out val ve coil termina ls. Never apply a ju mper across (o r short) the valve coil te rminals , even t emporari ly . After s ervicing , verify pr oper syste m operatio n.
69-1226—2 G .R. Rev . 11-99 www .honeywell.com Printed in U.S.A. on recycled paper containing at least 10% post-consumer paper fibers. Automation and Control Solu tions Honeywell Intern ational Inc. Honeywell Limite d-Honeywell Limit ée 1985 Douglas Drive North 35 Dynamic Drive Golden Valley, MN 55 422 Scarborough, Ontar io M1V 4Z9 69-1226-2.
P.O. Box 80400, Simpsonvill e, S.C. 29680-0400, USA http://www.bkideas.co m Made and printed in t he U.S.A LI0175/0807.
Een belangrijk punt na aankoop van elk apparaat Bakers Pride Oven DRG-40 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Bakers Pride Oven DRG-40 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Bakers Pride Oven DRG-40 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Bakers Pride Oven DRG-40 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Bakers Pride Oven DRG-40 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Bakers Pride Oven DRG-40 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Bakers Pride Oven DRG-40 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Bakers Pride Oven DRG-40 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
