Gebruiksaanwijzing /service van het product BDI460SS van de fabrikant Baumatic
Ga naar pagina of 44
BDI460SS 46 cm High compact dishwasher.
USER MANUAL FOR YOUR BAUMATIC BDI460SS 46 cm High compact dishwasher NOTE : This User Instruction Manual contains imp ortant information, including safety & installation p oints, which will enable you to get the most out of your appliance.
3 Contents E n v i r o n m e n t a l n o t e 4 Important safety information 5 – 7 S p e c i f i c a t i o n s 8 - 9 Product and aperture di mensions 8 P r o d u c t s p e c i f i c a t i o n s 8 - 9.
Environmental note o The packaging materials that Baum atic uses are environmentally friendly and can be recycled. o Please discard all packaging mate rial with due regard for the environment.
IMPORTANT SAFETY INFORMATION Y o u r s a f e t y i s o f t h e u t m o st importance to Baumatic. Please make sure that you re ad this instruction booklet before attempting to install or use the appliance. If you are unsure of any of the information contained in this booklet, please contact the Baumatic Advice Line.
6 o Care should be taken not to trap the power supply cable underneath the appliance whilst installing it. o No attempt should be made to al ter or modify the specifications of this appliance. In daily use o This appliance is only design ed to wash normal domestic washloads.
7 Child Safety o Your dishwasher should only be used by adults. You should not allow children in the area of the machine unsupervised. You should not let them touch the cont rols or play with the appliance. o It could be possible for a child or pet to gain access to the dishwasher if the door is left open.
Specifications Product and aperture dimensions Product dimensions Aperture dimensions Height: 457 mm Height: 450 mm Width: 598 mm Height: 460 mm Depth: 568 mm (built under) Width: 560 mm Depth: 560 mm.
o Electronic aqua stop o Delay start o LED display o Residual drying o Concealed heating element o Mark resistant coating o Self-cleaning stainless steel micro-filter o Anti-leak device o Anti-flood d.
Control panel A) ON/OFF key B) Program selection key C) Delay start key C1) Delay start icon D) Additional rinse key D1) Additional rinse icon E) “3 in 1” key E1) “3 in 1” icon F) Start progra.
Using your dishwasher Before first use o Install the appliance as per the installation instructions contained within this booklet. o Fill the water softener with 1 litre of tap water and then fill with specialist dishwasher salt. After this you should set the water softener level.
o Pour salt into the water softener, you should add approximately 1 kg of salt into the water softener. o It is perfectly normal for a small amount of water to come out of the water softener, whilst you are filling it with salt. This does not mean that the water softener is filled with the correct amount of salt.
Y o u s h o u l d a d j u s t t h e a m o u n t o f s a l t t h a t i s r e l e a s e d b y t h e m a c h i n e taking into account the water hardne ss of your geographical area, to do this you should:- o Close the door of the dishwash er, you will hear a mechanical click when the door of the di shwasher is shut properly.
o Slowly pour in liquid rinse aid, the rinse aid dispenser will hold approximately 100ml of rinse aid. o You should continue to fill with rinse aid until the dispenser is full. Be careful not to overfill the dispenser, as this could cause oversudsing when a wash progra m is selected.
o When the LED display shows the rinse aid setting that you require, press the program selection button to confirm your choice. The LED display will show “P0” to indicate that the dishwasher is ready to program. o If you get water spots and poor drying performance, then the rinse aid level should be increased to a higher level.
o If you are using powder detergent, t h i s s h o u l d a l s o b e p l a c e d i n one of the corners of the drip tray. You should refer to the manufacturer’s instructions when it comes to the amount of power detergent to use per wash cycle. o IMPORTANT: We do not recommend that you use liquid detergent in this appliance.
o Loading with a mixture of plates and saucepans o Saucepans and serving bowls must always be placed with their bases upwards. o Deep saucepans should be slante d, to allow water to run off.
Loading dishes and cutlery Household cloths, sponges or any other object that may absorb water SHOULD NOT be washed in a dishwasher. o Remove leftovers and soften the re mnants of burnt food in pans, prior to loading dishes in the appliance. o Once the dishwasher has been lo aded, check that the spray arm can move freely.
The following items are NOT suitable for washing inside a dishwasher:- o Cutlery with a handle of mother-o f-pearl, wood, horn or china. o Plastic items that are not resistant to heat. o Cutlery that consists of glued part s that are not resistant to heat.
Program table Wash program LED display information shown P1 (50°C Economy) P2 (70°C Intensive) P3 (65°C Normal)* P4 (40°C Rapid) P5 (70° Powerful) * Normal is the testin g program for EN 50242.
Opening and closing the door o Pull the dishwasher hand le to open the door, continue to pull forward until the drawer co mes out of the appliance. o IMPORTANT: The door should only be opened when the door locked icon (N) is not lit.
22 o Check whether the salt required icon (J) or rinse aid required icon (K) are lit. If they are and you usually utilise separate salt and rinse aid, then before continuing with the wash program you should fill the dishwasher wi th salt and/or rinse aid.
23 At the end of a wash cycle o When the wash cycle has comple ted, the LCD display will show “0” and an audible signal will sound. The “0” will disappear from the LCD display after 10 minutes but the audible signal will repeat every 10 minutes, until th e dishwasher is switched off.
Additional rinse option If you are washing dishes that are very heavily soiled, then it is possible to program the dishwasher so that it gives an additional rinse during the wash program. o After you have selected a wash cycle (as described on pages 21 – 22), press the additional rinse key (D) to select the additional rinse option.
25 Setting a delay start It is possible to delay the start of the wash program for a maximum of 9 hours. o After you have selected a wash cycle (as described on pages 21 – 22), press the delay start key (C) . The LED display will show “d1”, indicating that the start of the wash cycle has been delayed by 1 hour.
Rinse aid and salt indicator neons o The rinse aid and salt indicator neons on the control panel will let you know when the appliance needs rinse aid or salt adding to it. o The neon indicates that you need to add rinse aid to the appliance. You should follow the procedure outlined on pages 13 - 14.
o When placing the basket back in side of the dishwasher, insert the basket wheels into the basket wheel guides. o Slide the basket fully into the dishwasher and then refasten the basket to the support on the inside of the door (as shown in the picture opposite).
The filter system Your appliance is fitted with three levels of filtering; these are located in the base of the dishwa sher for ease of access. 1) Main filter 2) Coarse filter 3) Fine filter Main filter- Food and soil particles are trapped by this filter and pulverised by a special jet on the lower spray arm.
Cleaning the filters For best performance and results, the entire filter assembly should be thoroughly cleaned regularly (ide ally after each wash cycle). o Remove the basket from the appliance. o Identify the coarse filter, which is located in the middle of the main filter.
IMPORTANT: THE DISHWASH ER SHOULD NEVER BE SET ON A WASH CYCLE WI THOUT THE FILTERS BEING INSIDE OF THE APPLIANCE. The drip tray The drip tray is positioned under the basket and it is designed to catch dirt and food residue that may drop from items when they are placed in the dishwasher.
o Slide the drip tray back into th e dishwasher, with the upper and lower plates closed together. Maki ng sure that the wheels locate into their guides at the side of the dishwasher tank. o Once the wheels have reached thei r rear limit, you should gently slide forward the upper plate only an d clip this onto the drip tray catch fastener.
Cleaning the door o To clean the edge around the outs ide of the door, you should use a soft, damp cloth only. o To prevent water from penetratin g the door lock or electrical components, DO NOT use a spray cleaner of any kind. o DO NOT use any abrasive cleaner or scouring pads on the inner or outer surfaces, as they may cause damage to them.
33 Error code failure system If your appliance senses that it is not operating correctly, then an error code may appear on the LED display and/or the warning icon (I) may light. The following error codes can possibl y be remedied by the customer and the steps outlined below should be followed.
After taking the necessary action to clear the fault code, you should switch the machine off using the ON/OFF key (A) . Wait for a few seconds before switching th e machine back on again.
35 General troubleshooting Start up problems The appliance does not start The socket does not work. The appliance is not properly connected. The dishwasher is not properly closed. The water tap is closed. There is no water supply to the property.
36 Poor wash results Residue remai ns on dishes. The dishes were not properly arranged or there are too many of them. Some of the dishes are touching o ne another. The spray arm cannot turn because of a large plate or saucepan being placed in the dishwasher.
Installation Installation of this appliance must be carried out by a suitably qualified person, in a ccordance with the current version of the following. o UK Regulations and Safety Stan dards or their European Norm Replacements. o Building Regulations (issued by the Department of the Environment).
Installing the dishwasher into a kitchen cabinet o Ensure that the aperture that yo u will be fitting the dishwasher into is of the size given in the diagram above. o Ensure that the rear panel of the furniture housing unit has been removed and that the ventilation cut out shown is adhered to.
o Open the door of the dishwasher and then fix it to the housing unit, using the four screws prov ided. These should be screwed through the dishwasher cabinet an d into the housing unit. These screws must be fully tightened. Connecting to the mains water supply 39 ed.
Water outlet 9 Connect the drain hose to the rear of the appliance. 9 Place the end of the drain hose on your drain pipe. Push it a short way down into your drain pi pe. The drain hose should be in the shape shown in the above line drawing. 9 IMPORTANT: Do not place the drain hose higher than 800 mm.
9 NEVER EXTEND THE DRAINAGE HOSE FROM ITS ORIGINAL LENGTH. Power supply 9 IMPORTANT: The electrical socket must still be accessible once the appliance is installed. 9 Consult the rating plate, located on the right hand of t he inner surface of the door BEFORE making the electrical connections.
42 9 IMPORTANT: We do not recommend that this appliance is connected to an extension lead. Before first use You should check the following before using the appliance for the first time:- o That the dishwasher is level and fixed in position. o That the water tap is fully open.
United Kingdom Baumatic Ltd., Baumatic Buildings, 6 Bennet Road, Reading, Berkshire RG2 0QX United Kingdom Sales Telephone (0118) 933 6900 Sales Fax (0118) 931 0035 Customer Care Telephone (0118) 933 6911 Customer Care Fax (0118) 986 9124 Spares Telephone (01235) 4372 44 Advice Line Telephone (0118) 933 6933 E-mail: sales@baumatic.
44 44.
Een belangrijk punt na aankoop van elk apparaat Baumatic BDI460SS (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Baumatic BDI460SS heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Baumatic BDI460SS vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Baumatic BDI460SS leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Baumatic BDI460SS krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Baumatic BDI460SS bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Baumatic BDI460SS kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Baumatic BDI460SS . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
