Gebruiksaanwijzing /service van het product tr-200p van de fabrikant Telex
Ga naar pagina of 23
T elex Operating Instructions MODEL TR-200, TR-200P WIRELESS BELT-PACK TRANSCEIVER T E L EX RadioCom .
Table of Contents Page INTRODUCTION .......................................................................................................1 General Description ..........................................................................................
INTRODUCTION General Description The T elex Model’ s TR-200 and TR-200P Belt-pack T ransceivers, are designed with one transmit and one receive channel and will operate on selected frequencies within the 150 to 216 MHz band. The TR-200 T ransceiver operates in the continuous transmit mode with the audio, or talk, activated by a switch.
Figure 1 Block Diagram of TR-200 T ransceiver -2-.
TECHNICAL INFORMA TION Controls and Connections Figure 2 External controls and Connections -3- BEL T CLIP LOW BA TTER Y / OVERMODULA TION INDICA TOR LED T ALK INDICA TOR LED PUSH-TO-T ALK/ LOCK-TO-T A.
Figure 3 Internal Controls Features V olume ON/OFF Control: This thumbwheel control serves as both an on/of f switch and as a volume control. The transceiver is turned off when the control is in the extreme counterclockwise position, when viewed from the front, and the vol- ume is loudest when the control is in the extreme clockwise position.
Push-to-T alk/Lock-to-T alk Switch: For Model TR-200 , this switch enables the talk function. Press the button and hold down as long as required (Push-to-talk function), or if continuous talk is required (lock-to-talk function), quickly press the button two times to lock on.
-6- SPECIFICATIONS Overall Po wer Requirements ....................6 AA cells (Alkaline, NED A, MN 1500) Nickel Cadmium Optional Current Drain ..........................................................................typical 65 mA T emperature Range .
SET-UP Unpacking: Unpack your TR-200 System. If there are any defects or shortages, re- fer to the “W arranty Service Information” section in this manual. Headset Connection: Insert the headset/microphone into the connector on the bot- tom of the unit.
Figure 6 Dynamic/Electret Switch Battery Installation: Assure that the OFF/ON V olume control knob is turned OFF . Gain access to the battery compartment by removing the belt clip on the back of the unit. Release the 1/4 turn fastener located on the back of the belt clip and re- move the belt clip/cover .
Battery Check : Rotate the V olume ON/OFF Control knob clockwise to turn the unit on. Note that the battery LED (Labeled bat/ ovmod) should flash one time on good batteries. Poor batteries will cause the LED to be illuminated continuously and a bad or unusable battery will not cause any illumination at all.
Dressing the Unit: It is suggested that the unit be worn on the belt or pocket with both antenna’ s hung vertically for best operating range and performance.
OPERA TION Power: Rotate the ON/OFF - V olume Control Switch counterclockwise to turn the unit on. Refer to the Battery Check Section and check batteries. After batteries have been checked, adjust the volume control by rotating the control either clockwise or counterclockwise as required for comfortable listening volume.
Adjusting Microphone Gain: If the transmitted audio from the microphone is too high or too low , remove the belt clip on the rear of the unit and pry out the small rubber plug to the right of the screw boss. This will reveal the microphone gain control potentiometer .
BA TTER Y INFORMA TION General Improper battery selection, use, installation and care are the cause of numerous wireless system failures. Alkaline Batteries: Alkaline batteries such as Mallory’ s DURACELL or Eveready’ s ENERGIZER provide the most reliable operation in wireless transceiv- ers.
RECOMMENDED HEADSETS V-Series (See pages 17 and 18 for Ordering Information) Earphone Frequency Response ..........................................10 Hz - 20 kHz Earphone Input Sensitivity .................................................90d B@1m W Microphone Frequency Response Dynamic (MB-11) .
Recommended Headsets Continued PH-1 Catalog No. .................................................................................64438-005 Earphone T ype ...................................................................Dynamic/Single Earphone Impedance.
Recommended Headsets Continued PH-8 Catalog No. .................................................................................70415-001 Earphone T ype ....................................................................Dynamic/Mono Earphone Impedance.
ACCESSORIES Headsets PH-1 Order No. 64438-005 PH-2 Order No. 64437-006 PH-4 Order No. 70340-000 PH-8 Order No. 70415-001 PH-10 Order No. 70470-003 PH-16 Order No. 70770-003 V-series Headsets V-210 Single sided headset with boom Order No. 300027-001 V-220 Double sided headset with boom Order No.
ACCESSORIES (Continued) V-Series Cord Assemblies (Continued) CA-20 XLR-4 Female 5’ cord Order No. 300029-001 CA-22 XLR-4 Male 5’ cord Order No. 300029-000 CA-30 XLR-5 Female 5’ cord Order No. 300029-009 CA-33 XLR-5 Male 5’ cord Order No. 300029-004 CA-40 Sony mini 4-conductor 1/8" 5’ cord Order No.
NOTE: This manual is also used for the RTS version 2110/2105 Intercom sys- tem which uses a different headphone jack. Use the illustrations below in place of Figure 4 of page5.
-20- CUST OMER SER VICE INFORMA TION If your receiv er or transmitter should need servicing under the warranty , please con- tact: Customer Service Department TELEX COMMUNICA TIONS, INC. 8601 East Cornhusker Highway , P .O. Box 5579, Lincoln, Nebraska 68505-5579 U.
MADE IN U.S.A. APRIL 1998 PN 802205-2.
Een belangrijk punt na aankoop van elk apparaat Telex tr-200p (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Telex tr-200p heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Telex tr-200p vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Telex tr-200p leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Telex tr-200p krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Telex tr-200p bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Telex tr-200p kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Telex tr-200p . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
