Gebruiksaanwijzing /service van het product 13101-GTX 16 van de fabrikant Troy-Bilt
Ga naar pagina of 28
Models 13074 – GTX 18 (18 HP) 13076 – GTX 20 (20 HP) 13101 – GTX 16 (16 HP) Form 770-1177A (2/98) Owner/Operator Manual GTX Garden T ractor • Safety • Operation • Maintenance.
2 Thank you for purchasing this product. We feel you now own one of the finest pieces of outdoor power equipment available. All information in this manual is based on the latest product information available at the time of printing. This manual is considered a permanent part of the unit and must stay with the unit if resold.
W ARNING: Engine exhaust from this product contains chemicals known to the State of California to cause cancer , birth defects or other reproductive harm. Identification Numbers For prompt service, always provide the identification numbers of the unit.
Introduction 1. Unit is capable of amputating hands and feet and throwing objects. Failure to observe the following safety instructions could result in serious injury or death. 2. Serious accidents which may cause injury or property damage can occur if the following safety guidelines are not followed.
5 Before Operation 1. Before each use, clear work area of objects such as rocks, toys, wire, etc., which could be picked up and thrown by mower blades.
Safety (continued) 6 without either the entire grass catcher or the guard in place. 7. If you strike a foreign object, disengage attachment/PTO drive, shut off engine, wait for all moving parts to come to a stop. Remove ignition key. Inspect for and repair any damage before operating equipment again.
7 8. If unit is unable to continue moving uphill, disengage attachment drive (PTO), check area on ground immediately behind unit, watch area to rear and proceed backward slowly. 9. Do not operate unit on steep slopes where there is a risk of an overturn.
8 14. Check brake operation frequently. Adjust and service as necessary as indicated in Section 7 “Maintenance.” 15. Chock wheels (place blocks of wood in front and behind wheels) when performing maintenance with the parking brake off. Securely support unit if it must be raised for any reason.
9 1767130 Instruction/Safety Decal Safety (continued) 4. If electrolyte contacts skin or eyes: a. Flush affected area with water. b. Apply baking soda to neutralize acid. c. Flush eyes with water for 10-15 minutes. d. Call a physician immediately. 5. If electrolyte is swallowed: a.
10 Section 2 Attachments, Kits & Specifications Specifications Engine ....................................*16 HP Briggs and Stratton (GTX 16) *18 HP Kohler (GTX 18) *20 HP Kohler (GTX 20) Governor Speed ............................................
Attachment, Kits and Specifications (continued) 11 Number Description Below is a list of attachments and kits available for this tractor. The information below is the most current, available at the time this manual was printed. Check with your nearest authorized dealer for current information.
12 Auxilliary Hydraulic Lever (Model 13076 Only) (F) Brake/Neutral Pedal (B) Choke Lever (C) Attachment Lift Lever (G) Cruise Control Switch (Models 13074 & 13076) (D) Light Switch (E) Hour Meter .
Controls (continued) 13 A. Parking Brake Lever Locks brake. Set parking brake when unit is not in use. See page 19 for operating instructions. B. Brake / Neutral Pedal Stops forward or reverse movement of the tractor. See page 19. C. Choke Lever When activated, the choke restricts amount of air mixing with fuel.
14 Before starting the engine, perform the following steps: 1. Check Engine Oil Level Refer to your specific model in Figure 5-1. Remove dipstick (A, Fig. 5-1). Wipe oil from dipstick with a clean cloth. Insert dipstick back into place. Remove dipstick and check oil level.
Before Operation (continued) 15 Loosen adjustment knobs (ZZ), slide seat forward or backward. ZZ Fig. 5-3 4. V isually Check Check for and repair loose or missing screws, nuts, and damaged parts.
Section 6 Operation 16 5. When engine starts, move choke lever (G) down halfway (to half choke). Gradually, move choke lever down (to choke off) as the engine warms up. NOTE: DO NOT RUN ENGINE WITH CHOKE ON FOR PROLONGED PERIODS. ENGINE WILL RUN POORLY (OVER-RICH FUEL MIXTURE) IF OVER-CHOKED.
Operation (continued) 17 Interlock System Leaving the seat while the attachment/PTO drive switch (X, Fig. 6-1) is on or while the brake is off will stop the engine.
18 Operation (continued) Auxilliary Hydraulic Lever (Model 13076 Only) (L) Brake/Neutral Pedal (F) Attachment Lift Lever (K) Cruise Control Switch (Models 13074 & 13076) (O) Attachment/PTO Drive Switch (X) Throttle (J) Travel Pedal (M) Parking Brake Lever (N) Ignition/Starter Switch (H) Choke Lever (G) Light Switch (E) Fig.
19 Lock Parking Brake Unlock Parking Brake Parking Brake Lever N F Engage pedal (F) before pulling lever (N). Fig. 6-5 Operation (continued) Moving T ractor Manually DO NOT TOW OR PUSH THIS TRACTOR WITH ANOTHER VEHICLE OR RISK DAMAGING THE DRIVE SYSTEM.
Section 7 Lubrication and Maintenance 20 BEFORE PERFORMING ANY MAINTENANCE OR ADJUSTMENTS TO THE TRACTOR, ENGINE OR A TT ACHMENTS: DISENGAGE THE A TT ACHMENT/PTO DRIVE, SHUT OFF THE ENGINE AND WAIT FOR ALL MOVING P AR TS TO STOP . SET THE P ARKING BRAKE AND ALLOW THE ENGINE AND MUFFLER TO COOL.
Maintenance (continued) 21 4. Close oil drain valve (L). Place cap on oil drain tube. Install side panel. Engine Air Intake Screen STOP ENGINE BEFORE CLEANING AIR SCREEN! Check engine air intake screen (C, Fig. 7-1) for debris and clean regularly. A dirty air screen and engine can reduce airflow and cause the engine to overheat.
22 2. Adjust screws (N, Fig. 7-5). These screws apply pressure to the front axle. Axle should pivot with a small amount of drag. Fr ont Wheel Alignment Straighten front wheels. Loosen locknuts (Q, Fig. 7-5). Adjust tie rod (Z) so measurement (O) is 1/8" longer than measurement (P).
Maintenance (continued) 23 Pr oper Jack Placement A floor jack (not a bottle jack) or an overhead hoist may be used to lift the front of the tractor. Do not attempt to use any other device to lift the tractor. USE EXTREME CARE WHEN JACKING OR HOISTING TRACTOR.
Maintenance (continued) 24 C A D G H E F L J Fig. 7-9 Transmission Oil Filter: Replace filter after first five hours and every 100 hours thereafter. Filter is located under the tractor, in front of the transmission. Hydrostatic Neutral Adjustment Hydrostatic neutral is set at the factory.
Maintenance (continued) 25 Lubrication Chart Engine Crankcase First 5 hours Hydrostatic Transmission Front Wheel Spindles Front Axle Pivot See engine manual Lubrication intervals vary with operating conditions and type of oil used 1-Speed Units: Use SAE 20 wt.
Maintenance (continued) 26 T roubleshooting Chart Engine turns over but won't start. Engine will not turn over. Engine doesn't turn over but start light comes on. Starts only after repeated tries. Stalls in a few seconds. Stalls when hot. Idles rough.
Maintenance (continued) 27 Storing the T ractor Always store tractor in a dry and protected place when not in use. If tractor will not be used for a season, store it in the following manner. 1. CLEAN: Completely clean all accumulated dirt or grass from all parts – especially engine fins, transmission cooling fins and engine air intake screen.
© 1997 Garden Way Incorporated Printed in the U.S.A. For customer assistance, contact your nearest authorized dealer or: GARDEN WAY INCORPORATED • 1 Garden Way • Troy, New York U.S.A. 12180 Customer Service: 1-800-437-8686 • Technical Service: 1-800-520-5520 • Parts Service: 1-800-648-6776 • FAX: (518) 391-7332 Outside the U.
Een belangrijk punt na aankoop van elk apparaat Troy-Bilt 13101-GTX 16 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Troy-Bilt 13101-GTX 16 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Troy-Bilt 13101-GTX 16 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Troy-Bilt 13101-GTX 16 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Troy-Bilt 13101-GTX 16 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Troy-Bilt 13101-GTX 16 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Troy-Bilt 13101-GTX 16 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Troy-Bilt 13101-GTX 16 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
