Gebruiksaanwijzing /service van het product HOTBLAST 1950 van de fabrikant United States Stove
Ga naar pagina of 20
INSTALLATION AND OPERATING INSTRUCTIONS FOR THE HOTBLAST 1950 EPA WOOD BURNING FURNACE Verified and tested following CSA B366.1 M91, UL 391-95, 99 by : Intertek Testing Services Distributed by: UNITED STATES STOVE COMPANY 227, INDUSTRIAL PARK ROAD P.O.
Please keep this document TABLE OF CONTENTS INTRODUCTION ...................................................................................................................... 2 1. CHIMNEY AND DRAFT ....................................................
INTRODUCTION Take note that this furnace operates like an EPA wood bu rning stove. This applies to the lighting, the embers and the minimum combustion air intake which depends on the type and the grade of the combustible. This model line is certified as meeting the emissi ons limits in 40 C.
W A R N I N G -THE ASH DRAWER AND EXCHANGERS ACCESS PA NEL GET VERY HOT. -DO NOT MANIPULATE WITH BARE HANDS. 2.2 ODOUR FROM THE PAINT It is normal that a smoke odour emanate from the unit when y ou first light it. It is recommended to burn it at high rate and ventilate the building until the odour resorbs.
2.5 SMOKE DETECTOR We highly recommend the use of a smoke det ector. It must be installed at least 15 feet (4,57 m) from the appliance in order to prev ent undue triggering of the detector wh en reloading.
3. APPLIANCE INSTALLATION 3.1 UNIT LOCATION The furnace must be installed where outsi de air supply is sufficient for prop er combustion. In airtig ht houses, it might be necessary to install an outside air inlet (see details in section 3.
3.3 PIPE CONNECTOR AND DAMPER Before proceeding to connection, remove all accessories such as scraper, shovel and poker from the evacuation pipe of the furnace. A 7” diameter chimney listed for use with wood burning hea ting appliances is highly recommended for the Hotblast 1950.
DAMPER The barometric control must be adjusted so that t he maximum draft measured at the furnace outlet is limited to - 0.06 in. w.c. Please note t hat a draft higher than -0.06 in. w.c. could result in an uncontrolla ble fire. On the other hand, the minimum draft to be respected is -0.
3.5 ELECTRICAL CONNECTION The following instructions do not supersede the local cod e. HOTBLAST 1950 On the Hotblast 1950 the combined limit control is installed with the support provided on the left side of the appliance (two holes are predrilled o n the edge of the furnace), and conne cted to the electrical box along with the transformer.
4. OPERATING INSTRUCTIONS Control system On the wood only furnaces , the thermostat controls the air inlet damper. When the thermostat calls for heat, the damper opens and th e fire burns up. When the furnace ge ts hot enough, the combined limit control activates the blower motor at the speed selected for woo d heating.
4.3 HEATING 1. When loading the furnace , spread the coal and em bers evenly in the center of the combu stion chamber before adding new logs. 2. Do not overload. Air must circulate freely in the upper part of the combustio n chamber in order to obtain an efficient operation of the appliance.
Whenever a high amount of smoke is noticed in the room, you mu st: 1. Open doors and windows. 2. Make sure the furna ce door is closed a s well as the dam per (if necessary, lower the thermo stat starting point or undo the chain of the damper and clo se t he barometric draft control manually).
5. MAINTENANCE 5.1 MAINTENANCE OF THE EXCHANGERS The evacuation pipe and the exchangers should be insp ected regularly durin g the bur ning season. Easy access is provided (without the use of tools): unscrew the wing nut on the exchangers access door.
5.2 CHIMNEY MAINTENANCE One of the most efficient methods is t o sweep the ch imney is using a hard brush. Brush the chimney downward so soot and creosote residues will com e off the inside su rface and fall at the bottom of the chi mney where it can be removed easily.
Door adjustment procedure: 1. Unscrew com plete ly the locking pin (see picture below). Lockin g p in 2. To increase t he pressure of the door on the gasket, turn the handle counter clo ckwise; to decrease the pressure on the door on the gasket, turn the handle clo ckwise.
7. WIRING DIAGRAM HOTBLAST 1950 WOOD DIRECT DRIVE RED ON 150°F LIMIT 250°F OFF 110°F LIMIT LOAD FAN LINE HONEYWE LL L6064 HIGH LINE LOW L2 120 V.A.C. L1 BLACK TRANSFO JUNCTION BOX 24 V.A.C. 24 V.A.C. THERMOSTAT SERVO-MOTOR RED BLACK WHITE BLACK BLACK 24 V.
8. HOTBLAST 1950 TECHNICAL DATA HOTBLAST 1950 A 47” B 25 ½” C 47 ¼” D 15 ⅞ ” E 28” F 24 ½” G 44” FLUE * 7” WEIGHT 560 * Reducer requi red 8.1 GENERAL TECHNICAL DATA MODEL DIRECT DRIVE OUTPUT TEMP VAR. BTU/ HR STATIC PRESSURE FILTER FAN MOTOR SPEED (CFM) ( O F) (WOOD) MIN.
9. DUCTS AND DAMPERS DIMENSIONS (EXAMPLES OF CALCULATION) SIMPLIFIED METHOD DISTRIBUTION SYSTEM Ducts size (heat) 4 inch outlet reduce by 1” 5 inch outlet reduce by 2” Always by 8” thick 6 inch outlet reduce by 3” N.B.: The main duct must be reduced every 2 outlets.
10. HOTBLAST 1950 BRICKS LAYOUT WARNING: INSTALL THE CERA MIC BLANKET PANEL BEFORE PUTTING BRICKS UP IN THE COMBUSTION CHAMBER 9" 4 1/2 " 3 1/ 2" 5 1/2" 9 4" 1 5/8 " 9&qu.
19 11. TROUBLE SHOOTING PROBLEM CAUSES SOLUTIONS Heating inefficient during the first combustions. Lack of draft. Improper adjustment of the barometric damper (ope ned too wide). Chimney flue restriction (too long., or too many 90 o elbows) Adjust the damper, minimize the chimney length and use 45 o elbows.
Een belangrijk punt na aankoop van elk apparaat United States Stove HOTBLAST 1950 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen United States Stove HOTBLAST 1950 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens United States Stove HOTBLAST 1950 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding United States Stove HOTBLAST 1950 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over United States Stove HOTBLAST 1950 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van United States Stove HOTBLAST 1950 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de United States Stove HOTBLAST 1950 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met United States Stove HOTBLAST 1950 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
