Gebruiksaanwijzing /service van het product 80 van de fabrikant Weil-McLain
Ga naar pagina of 40
P art N o. 550-141-935/0602 Boiler Manual 80 W ater & steam boilers for use with Gas, Light Oil, & Gas/Light Oil – Fired Burners This manual must only be used by a qualified heat ing installer/serv ice technician. R ead all inst ructions before installing.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 2 P art No . 550-141-935/0602 Hazar d Definitions The following defined terms are used thr oughout this manual to bring attention t o the presenc e of hazards of various risk levels, or to important information conc erning the life of the product.
• Installation • Start-Up • Maintenance • Parts 3 P art No . 550-141-935/0602 Installation must compl y with — • State, pr ov incial and local plumbing, heating and electr ical codes. • R egulations of serv icing utilities. • N ational codes where applicable.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 4 P art No . 550-141-935/0602 Befor e installing boiler (continued) 1 Figure 2 Combustion and v entilation air openings — Boil.
• Installation • Start-Up • Maintenance • Parts 5 P art No . 550-141-935/0602 Set boiler in place 2 For packa ged boiler: 1. Remo ve top jack et panels. Set aside until after boiler is piped. The boiler contains ceramic fiber and fiberglass materials.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 6 P art No . 550-141-935/0602 Assemble block 3 Sections are top heavy . U nbolted sections ma y fall if not supported, r esulting in seve re personal inj ury or death. Install bac k refractory blanket 1.
• Installation • Start-Up • Maintenance • Parts 7 P art No . 550-141-935/0602 Install intermediate sections Sections are top hea vy . U nbolted sections may fall if not supported, resulting in se ve re personal injury or death. 1. R emove and discar d 3 / 8 " diameter shipping tie r ods.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 8 P art No . 550-141-935/0602 Perform hydr ostatic pr essur e test Prepare boiler and test: 1. See pages 28 and 29 for tapping locations. I nstall: a. Boiler drain (not furnished).
• Installation • Start-Up • Maintenance • Parts 9 P art No . 550-141-935/0602 Install burner mounting plate on fr ont section 1. Install four ½" x 4¾" studs to secure burner mounting plate to section: a. Thread and lock together two nuts on r ounded end of stud.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 10 P art No . 550-141-935/0602 Install flue collector 6 Figure 8 Collector hood preparation Figure 9 Flue collector sealing rope installation Flue collector assembl y 1. Figure 10, pag e 11, shows fl ue collector compo nents and locations.
• Installation • Start-Up • Maintenance • Parts 11 P art No . 550-141-935/0602 Install flue collector (continued) 6 Figure 10 Flue collector components, typical (Model 880 collector configurat.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 12 P art No . 550-141-935/0602 Install flue collector (continued) 6 Before installing flue collector 1. See Figure 10, page 11, for general assembly of flue collector c omponents.
• Installation • Start-Up • Maintenance • Parts 13 P art No . 550-141-935/0602 Figure 11 Flue collector components by model (see Figure 10, page 11 f or flue collector components not shown bel.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 14 P art No . 550-141-935/0602 Connect water boiler piping 7 General water piping information: • Syst em wat er supply and r eturn piping should b e installed and piping connections attach ed to boiler befor e erecting jacket or installing co ntrols.
• Installation • Start-Up • Maintenance • Parts 15 P art No . 550-141-935/0602 Connect water boiler piping (continued) 7 3. Piping for multiple boilers (see Figure 13): A Size seco ndar y boiler pump GPM based on following form ulas: Calculat e only secondary piping circuit resistanc e.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 16 P art No . 550-141-935/0602 Connect steam boiler piping 8 General steam piping information: • Hartfor d loop piping arrangement and wet return are required fo r steam boile rs.
• Installation • Start-Up • Maintenance • Parts 17 P art No . 550-141-935/0602 Connect steam boiler piping (continued) 8 Figure 15 Model 380 through 580 steam boiler piping — NO TE minimum 24 inches betw een boiler water line and bottom of header .
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 18 P art No . 550-141-935/0602 T able 9 Condensate receiv er capacity Figure 18 Condensate piping to boiler Connect steam boiler.
• Installation • Start-Up • Maintenance • Parts 19 P art No . 550-141-935/0602 Figure 19 Multiple Steam Boiler Piping Gravity Condensate Return Connect steam boiler piping (continued) 8 A Pipe as shown for gr avity return systems, c onnecting point A t o the wet gravity return.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 20 P art No . 550-141-935/0602 Install jacket 9 Before installing jac ket 1. P ackaged boile rs • Install top jack et panels per instruc tions in this manual. 2. N on-packaged boilers • Follow the instructions in this section to install all jacket panels.
• Installation • Start-Up • Maintenance • Parts 21 P art No . 550-141-935/0602 Figure 20 Installing jack et suppor t brack ets and rails and jac ket front and rear panels Install jacket (conti.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 22 P art No . 550-141-935/0602 Figure 21 Installing (removing) jack et side panels and top panels Install jacket (continued) 9 Install jacket side panels 1. Re move jack et side panels from cartons.
• Installation • Start-Up • Maintenance • Parts 23 P art No . 550-141-935/0602 Figure 22 Jac ket side panel placement — Models 380, 480, 580 and 680 Install jacket (continued) 9.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 24 P art No . 550-141-935/0602 Figure 23 Jac ket side panel placement — Models 780, 880 and 980 Install jacket (continued) 9.
• Installation • Start-Up • Maintenance • Parts 25 P art No . 550-141-935/0602 Figure 24 Jac k et side panel placement — Models 1080, 1180, and 1280 Install jacket (continued) 9.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 26 P art No . 550-141-935/0602 Figure 25 J ack et top panel placement Install jacket (continued) 9.
• Installation • Start-Up • Maintenance • Parts 27 P art No . 550-141-935/0602 T o pipe tankless heaters: 1. Size piping no smaller than heater inlet and outlet. 2. A uto matic mixing valve must be installed. See Figure 26. Follow manufact urer’ s instr uctions to install.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 28 P art No . 550-141-935/0602 Install water boiler controls Install controls: 1.
• Installation • Start-Up • Maintenance • Parts 29 P art No . 550-141-935/0602 Install steam boiler controls 12 Install controls: 1. Install controls whe re shown in T able 12 and Figure 28.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 30 P art No . 550-141-935/0602 Install steam boiler contr ols (continued) 12 Figure 29 Steam control siphon and fittings T able .
• Installation • Start-Up • Maintenance • Parts 31 P art No . 550-141-935/0602 13 Connect br eeching and venting systems Figure 31 Stub vent – f orced draft — single boiler Figure 33 Conv .
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 32 P art No . 550-141-935/0602 Install bur ner 14 Wiring and fuel piping Make final adjustments 16 15 T o install burner: 1. U npack b urner . 2. Place gasket around air tube and against burner mounting flange.
• Installation • Start-Up • Maintenance • Parts 33 P art No . 550-141-935/0602 Make final adjustments (continued) 16 Figure 35 Flue damper assembly , typical Skim steam boilers: Clean all newly installed steam boilers to remov e oil.
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 34 P art No . 550-141-935/0602 Dimensions and ratings 17 Notes 1. Burner input based on maximum of 2,000 feet altitude. For higher altitudes consult local Weil-McLain representative.
• Installation • Start-Up • Maintenance • Parts 35 P art No . 550-141-935/0602 17 Dimensions and ratings (continued).
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 36 P art No . 550-141-935/0602 18 Parts.
• Installation • Start-Up • Maintenance • Parts 37 P art No . 550-141-935/0602 18 Parts (continued).
W eil-McLain 80 Boiler For Gas, Light Oil, Gas/Light Oil Fir ed Burners 38 P art No . 550-141-935/0602 Handling ceramic fiber and fiberglass materials REMO V AL OF COMBUSTION CHAMBER LINING OR BASE P ANELS The combustion chambe r lining or base insulation panels in this product contain c eramic fiber materials.
• Installation • Start-Up • Maintenance • Parts 39 P art No . 550-141-935/0602 P ropane boilers — propane gas odorant Pr opane boilers o nly — Y our pr opane supplier mix es an odorant w ith the pro pane to make its prese nce detectable. In some instances, the odor ant can fade and the gas may no longer ha ve an odor .
W eil-McLain Limited W arranty f or Residential & Commercial Cast Iron Boilers ◆ ◆ ◆ ◆ ◆ RESIDENTIAL W A TER W ARRANTY—Limited Lifetime ◆ ◆ ◆ ◆ ◆ RESIDENTIAL STEAM W ARRANTY.
Een belangrijk punt na aankoop van elk apparaat Weil-McLain 80 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Weil-McLain 80 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Weil-McLain 80 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Weil-McLain 80 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Weil-McLain 80 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Weil-McLain 80 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Weil-McLain 80 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Weil-McLain 80 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
