Gebruiksaanwijzing /service van het product BI70MLPG van de fabrikant Belling
Ga naar pagina of 44
Belling Built-in Gas 083137303 17 .12.2012 Users Guide & Installation Handbook.
contents & IntRoDUctIon CONTENTS • SAFET Y • USING THE PRODUCT • CLEANING • INST ALLA TION INSTRUCTIONS • TECHNICAL DA T A • CUSTOMER CARE INTRODUCTION Thank you for buying this British- built appliance from us.
Safety 5.1 BEFORE USING THE PRODUCT Make sure that you ha ve removed all packaging and wrapping. Some of the items inside this appliance may have additional wrapping. Please note:- these safety warnings cover both gas and electric products. GENERAL WARNING! - The appliance and its accessible parts become hot during use.
Safety 5.1 affect the saf ety and performance, particularly in relation to surf ace temperatur es becoming hot and gas oper ated parts not workingefciently . The cooling fan (if tted)isdesigned to run on after the control knob has been switched off .
Safety 5.1 on the base of the oven or cover the o ven base with foil, as this can cause the base element to overheat. WARNING! - The top element gets extremely hot when in use, so take extr a care to avoid touching it. WARNING! - Do not modify the outer panels of this appliance in any w ay .
Safety 5.1 Do Not • Never place items on the door while it is open. • Never wrap f oil around the oven shelvesorallowfoiltoblocktheue. • Never drape tea towels near the o ven whileitison;thiswillcauseare hazard.
USING THE GRILL - ELECTRIC (If fITTEd) 7 .130 Caution: Accessible parts may be hot when the grill is used - young children should be kept away. a grill pan handle can be purchased as an optional extra from our spar es department quoting the numbers below .
7 .000 Caution: Accessible parts may be hot when the grill is used - young children should be kept away. a grill pan handle can be purchased as an optional extra from our spar es department quoting the numbers below .
using the top oven - gas USING THE TOP OVEN Ignition Push in and turn the top oven control knob to the ‘FULL ON’ position. Hold the control knob in, and press the ignition switch(iftted)orholdalightedmatch or taper to the burner , until the burner lights.
using the top oven - gas OVEN FURNITURE Baking tray and roasting tins For best cook ed results and even brown- ing, the maximum size baking tra ys and roasting tins that should be used are as follows;.
using the top oven - gas Dish Recommended gas mark Suggested shelf position Approximate cooking time (preheated Scones Meringues 7 “S” slow setting top - middle bottom 10 - 15 mins.
using the top oven - gas Traditional fruit cakes It should be remembered that ovens can vary ov er time, therefore cooking times canvary ,makingitdifculttobeprecise when baking fruit cakes. It is necessary therefore, to test the cake beforeremov alfromtheoven.
using the top oven - gas Cook in oven at Gas Mark 5 Approximate Cooking Time Beef Rare Medium W ell done 20minutesper450g(1lb),plus20.
USING THE MAIN OVEN - GAS USING THE MAIN OVEN Ignition Push in and turn the main oven control knob to the ‘FULL ON’ position. Hold the control knob in, and press the ignition switch(iftted)orholdalightedmatch or taper to the burner , until the burner lights.
USING THE MAIN OVEN - GAS For roasting joints of meat or poul try , and for pot roasts preheat the ov en to gas mark 6 and cook for 30 minutes, then adjust the oven control to the “S” slow setting for the remainder of the cooking time. Slow cooking times will be about three times as long as conventional cooking times.
USING THE MAIN OVEN - GAS Traditional fruit cakes It should be remembered that ovens can vary ov er time, therefore cooking times canvary ,makingitdifculttobeprecise when baking fruit cakes. It is necessary therefore, to test the cake beforeremov alfromtheoven.
USING THE MAIN OVEN - GAS Roasting guide The times given in the roasting guide are only approximate, because the size andageofthebirdwillinuencecooking times as will the shape of a joint and the proportion of the bone. Frozen meat should be thoroughly thawed before cooking.
The clock on this product has two modes of operation, fully automatic or semi automatic. This product is intended for use on the semi-automatic mode only . If for some reason this mode has not been pre-set already , the following procedure shouldbeusedtosetittothismode:- 1.
SEMI-AUTOMATIC COOKING The duration method • Pressthefunctionbuttontwice,(1) which will skip past the Minute Minder . • TheLEDdisplaywillashtheword ‘dur’ ,(2)andthe‘A ’wil lashonthe left hand side of the display .
USING THE MINUTE MINDER (IF FITTED) ELECTRONIC MINUTE MINDER The digital timer enables you to set the time of day (24 hour clock) and the min- ute minder alarm. Setting the “Time of Day” • Switch on the electricity supply to the appliance. • Thedisplaywillash.
cleaning General • It is important to clean the product regularly as a build up of fat can af - fect its performance or damage it and may inv alidate your guarantee. • Always switch off y our appliance and allow it to cool down before you clean any part of it.
Cleaning REMOVING OVEN PARTS FOR CLEANING • The inner door glass panel can be removed f or cleaning but it must be replaced the right way up .
installation Beforeyoustart:Pleasereadtheinstruc - tions. Planning your installation will save you time and effort. Prior to installation, ensure that the local distribution conditions (nature of the gas andgaspressure)andtheadjustmentof the appliance are compatible.
INSTALLATION - 60CM STEP 1 : PREPARE INSTALLATION Do not lift the appliance by the door handle. Whilst every care is taken to elimi- nate burrs and raw edges f rom this product,please take care when handling - we recommend the use of protective gloves during installation.
INSTALLATION - 60CM i)Wheninstalledinatypical600mm deep built in housing unit, the false back should be removed fr om the housing unit to provide the necessary depth for installation.
INSTALLATION - 70CM Before you start Please read the instructions carefully - planning your installation will save y ou time and effort. Look at the different w ays the appliance can be installed - as shown on the following pages - and plan the installation to suit your situation.
INSTALLATION - 70CM METHOD 1: WITHOUT HOUSING Before installing the appliance, check the internal dimensions as shown. The space for the appliance must be clear of obstruction.
INSTALLATION - 70CM METHOD 2: HOUSING UNIT WITH internal height less than 710mm. Note:Y ouwillnotneedthe2sidetrims (687mmlong)ortheappliancerunners for this installation. Y ou will need the 2 runnerstoxtotheadjacentcabinets.
INSTALLATION - 70CM METHOD 3: HOUSING UNIT WITH INTERNAL HEIGHT 710MM OR MORE Note:Y ouwillnotneedthe4runnersand 2 trims that are packed with the oven f or this installation.
INSTALLATION - 90CM STEP 1 : PREPARE INSTALLATION Do not lift the appliance by the door handle. Remov ethexingscrewsfromthe polythene bag on the top of the appli- ance, but leave the appliance in the base tr ay packaging until you are ready to install it.
INSTALLATION - 90CM Dimensions Theapplianceisdesignedtotintoa standard 600mm wide housing unit, with minimum internal dimensions as shown. Note:Allsizesarenominal,somev ariation is to be expected. Step 2 : Connect to gas supply 1.
installation Makesurethattheexible connector does not block the cooling fan inlet. 4. Flexible connections should comply with BS 669. Parts of the appliance lik ely to come into contactwithaexibleconnectorhavea temperature rise of less than 70°C.
installation For products without a plug This appliance must be connected by a competentperson,usingxedwiringvia a double pole switched fused spur outlet, with a contact separation of 3mm at all poles. Use a 13 amp fuse. W e recommend that the appliance is connectedbyaqualiedelectrician, who will comply with the I.
installation Step 4: Secure appliance into hous- ing unit Note:Theunithousingtheappliance mustbeappropriatelyxed.Ensurethat the appliance is centrally located. T ake care not to damage the appliance or cabinetry .
installation Theanti-staintrimisfactoryttedto the edges of the appliance front fr ame. This trim provides the cabinetry with extra protection fr om any escape of heat.
installation Commissioning Pressure test point Use the oven burner . From inside the oven remov e the burner cowl. Remove the small screw at the LHS of the burner cradle. Slide the burner to the left to ac- cess the injector . Connect suitable T -piece (incorporating a115injector)totheinjector .
TECHNICAL DATA 14.000 Data badge Lower part of front fr ame and rear of appliance Pressure setting G20 Natural Gas @ 20 mbar G30 Butane @ 28-30 mbar G31 Propane @ 37 mbar GAS DATA 60cm 70/90cm - Oven .
customer care FAQs What parts of the appliance can be washed in a dishwasher? • Any enamelled parts such as the grill pan can be cleaned in a dishwasher , as can oven shelves and shelf guides.
CUSTOMER CARE CUSTOMER CARE WEB SHOP Having purchased a superior cooker , hob or hood from us, you’ll naturally want to keep it looking great. And who better to help you care for it than the manuf ac- turer? W e offer an extensive r ange of accesso- ries, components and cleaning products which, will instantly give your cooker a good as new look.
customer care 15.040 CUSTOMER CARE CHANGING LIGHT BULBS Warning: There is a risk of electric shock, so alwa ys make sure you hav e turned off and unplugged your appliance bef ore starting. Always allow the product to cool down bef ore you change a bulb.
Please keep this handbook for f uture reference, or for an yone else who may use the appliance..
Please keep this handbook for f uture reference, or for an yone else who may use the appliance..
Please keep this handbook for f uture reference, or for an yone else who may use the appliance..
CUSTOMER CARE T o contact Belling about your appliance, please call Warranty Registration 0844 481 0182 to register your appliance Customer Care Helpline 0844 815 3746 incaseofdifcultywithintheUK Alternatively general, spar es and service information is available f rom our website at www.
Een belangrijk punt na aankoop van elk apparaat Belling BI70MLPG (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Belling BI70MLPG heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Belling BI70MLPG vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Belling BI70MLPG leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Belling BI70MLPG krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Belling BI70MLPG bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Belling BI70MLPG kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Belling BI70MLPG . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
