

heating elements. Children less than 8 years of age shall be kept away unless continuously supervised.


1 Cooking zone 2 Power indicator 3 Control knobs
180 mm · 145 mm

Residual heat
- 3 Heat settings
faster than usual plates. The red dots are painted on the plates. They can deteriorate during use and even disappear completely after a period of time. It does not have an effect on the performance of the hob.
Put cookware containing water on each cooking zone, set the maximum position and operate the hob for 10 min. This is to burn off the residue in the appliance. After that, operate the hob at minimum position for 20 min. During this period, an odour and smoke can occur. This is normal. Make sure that the airflow is sufficient.
To set or change the heat setting turn the knob to the correct heat setting. To deactivate turn the knob to off position.
Power indicator activates when one or more cooking zones are activated. When you deactivate the cooking zones the indicator deactivates.
A red dot in the middle of the plate shows a rapid hot plate. A rapid hot plate heats up
Heat set- ting:
Application:
The bottom of the cookware must be as thick and flat as possible.
2 Frying / browning
Bringing to the boil
3 Bringing to the boil / quick frying / deep-frying

General information
What to do if...
Problem Possible cause Remedy
You cannot activate or oper- ate the hob.
The hob is not connected to an electrical supply or it is connected incorrectly.
Check if the hob is correctly connected to the electrical supply. Refer to the connec- tion diagram.
The fuse is blown. Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician.
If you cannot find a solution...
will not be free of charge, also during the warranty period. The instructions about the Service Centre and conditions of guarantee are in the guarantee booklet.
If you cannot find a solution to the problem yourself, contact your dealer or an Authorised Service Centre. Give the data from the rating plate. Make sure, you operated the hob correctly. If not the servicing by a service technician or dealer

Stick the adhesive labels as indicated below:
MOD.
MOD.
MOD. PROD.NO. SER.NO.
PROD.NO.
PROD.NO.
SER.NO
03 IT
DATA
DATA
MADE IN ITALY
A. Stick it on Guarantee Card and send
C. Stick it on instruction booklet.
this part (if applicable). B. Stick it on Guarantee Card and keep
this part (if applicable).
and work surfaces that align to the standards.
Before the installation
Before you install the hob, write down the information bellow from the rating plate. The rating plate is on the bottom of the hob.
Model PNC Serial number
Only use the built-in hobs after you assemble the hob into correct built-in units

Possibilities for insertion
The panel installed below the hob must be easy to remove and let an easy access in case a technical assistance intervention is necessary.

40-50 mm min. 650 mm 490 mm min. 450 mm
Kitchen unit with oven The electrical connection of the hob and the oven must be installed separately for safety reasons and to let easy remove oven from the unit.
A. supplied seal B. supplied brackets

For optimal cooking results use cookware not larger than the diameter of the cooking zone.

Type of hob Built-In Hob
Number of cooking zones 2
Heating technology Solid Hot Plate
Diameter of circular cooking zones (Ø)
Middle front Middle rear
14.5 cm 18.0 cm
Energy consumption per cooking zone (EC electric cooking)
Middle front Middle rear
209.9 Wh / kg 209.9 Wh / kg
Energy consumption of the hob (EC electric hob)
209.9 Wh / kg
EN 60350-2 - Household electric cooking appliances - Part 2: Hobs - Methods for measuring performance
You can save energy during everyday cooking if you follow below hints.
Recycle the materials with the symbol . Put the packaging in applicable containers to recycle it. Help protect the environment and human health and to recycle waste of electrical and electronic appliances. Do not
dispose appliances marked with the symbol
with the household waste. Return the product to your local recycling facility or contact your municipal office.
Model identification PAM3000E
Veelvoorkomende problemen, mogelijke oorzaken en oplossingen.
| Probleem | Mogelijke oorzaak | Oplossing | |
|---|---|---|---|
| You cannot activate or oper- ate the hob. | The hob is not connected to an electrical supply or it is connected incorrectly. | Check if the hob is correctly connected to the electrical supply. Refer to the connec- tion diagram. | p.6 |
| You cannot activate or oper- ate the hob. | The fuse is blown. | Make sure that the fuse is the cause of the malfunction. If the fuse is blown again and again, contact a qualified electrician. | p.6 |
Eigenaren en ons team reageren doorgaans binnen een dag — en uw vraag helpt ook de volgende persoon.
Stel als eerste een vraag — andere eigenaren of ons team geven antwoord.