Gebruiksaanwijzing /service van het product CS-1201 van de fabrikant Echo
Ga naar pagina of 20
898 615-6073 2 X750 313-050 2 © 2003 W ARNING D ANGER READ INSTRUCTIONS CAREFULL Y AND FOLLO W RULES FOR SAFE OPERA TION. F AILURE T O DO SO COULD RESUL T IN SERIOUS INJUR Y .
2 CS-1201 INTRODUCTION ............................................................ 2 DECALS AND SYMBOLS ............................................ 2 RULES FOR SAFE OPERATION .................................. 2 PARTS IDENTIFICATION ................
3 CS-1201 CA UTION Stuffing ears with cotton is not recommended. • All persons who make part of their living using chain saws should be tested periodically for hearing deterioration.
4 CS-1201 2. KICKB A CK SAFETY PRECA UTIONS • In some cases, tip contact may cause a lightning-fast reverse reaction, kicking the guide bar up and back toward the operator (this is called a rotational kickback).
5 CS-1201 3. O THER SAFETY PRECA UTIONS • Do not operate a chain saw with one hand! Serious injury to the operator, helpers or bystanders may result from one-handed operation. For proper control, always use two hands when operating a chain saw, one of which operates the trigger.
6 CS-1201 WOOD PRA CTICES • Operating a chain saw safely requires a chain saw in proper working order, sound judgement, and knowledge of the methods which should be applied in each cutting situation. • Do not let any person use your saw unless he has read this operator’s manual and fully understands its instructions.
7 CS-1201 P AR TS IDENTIFICA TION Manual oil pump Air cleaner cover Spark plug cap Decompression button Front handle Oil tank cap Starter handle Fuel tank cap Rear handle Spiked bumpers Choke control .
8 CS-1201 Proper tension Improper tension CA UTION 1. All adjustments should be made cold. 2. Always wear glo ves when working on chain. 3. Do not operate with a loose chain. • Tighten both nuts with the bar nose held up . • Pull the chain around the bar by hand.
9 CS-1201 • Fill the fuel tank with fuel mixture. It is not permitted to fill fuel above the shoulder level of fuel tank. • Fill the chain oil tank with lubricant. • Place chain saw down on a clear level place where the saw chain will not be in contact with anything.
10 CS-1201 W ARNING D ANGER DO NO T LET THE NOSE OR TIP OF THE GUIDE BAR T OUCH ANYTHING WHILE ENGINE IS R UNNING T O A V OID KICKBA CK. CUTTING INSTR UCTION GENERAL In all circumstances the operation of the chain saw is a one-man job.
11 CS-1201 FELLING A TREE A falling tree can seriously damage anything it may hit - a car, a house, a fence, a power-line or another tree. There are ways to make a tree fall where you want it, so first decide where that is! Before cutting, clear the area around the tree.
12 CS-1201 LIMBING Limbing a fallen tree is much the same as bucking. Never remove a limb from a tree while it is supporting your weight. Be careful of the tip touching other limbs. Always use both hands. Don’t cut with the saw overhead or the bar in a vertical position.
13 CS-1201 CA UTION Do not touch hot surfaces of cylinder co ver and silencer after you used the c hain saw . TENSION AND COMPRESSION IN TIMBER A length of timber lying on the ground will be subject to tension and compression, depending at which points the major support is.
14 CS-1201 AREA MAINTENANCE PAGE BEFORE USE MONTHLY Air Filter Clean/Replace 15 • Fuel Filter Inspect/Clean/Replace 15 • Spark Plug Inspect/Clean/Adjust/Replace 16 • Carburettor Adjust/Replace a.
15 CS-1201 SER VICE CARBURETT OR • Do not adjust the carburettor unless necessary. • To adjust the carburettor proceed as follows: - Low speed mixture adjuster (L): 1 ¼ to 1 ¾ turns open - High speed mixture adjuster (H): 1 ½ turns open - Screw in the needles until lightly seated and return indicated turn above.
16 CS-1201 0.5 mm SPROCKET • The damaged sprocket will cause premature damage or wear of saw chain. - When the sprocket has worn out 0.5 mm or more, replace it. • Check sprocket when you install new chain. Replace it if worn. 0.6 to 0.7 mm SP ARK PLUG • Check periodically.
17 CS-1201 1 3 4 5 NO TE These angles are referred to as Oregon 27 saw chain. For other branded saw chain, follow it’s chain manufacturer’s instruction. Parallel A 30° BC 60° D 0.76 mm 85° SA W CHAIN MAINTENANCE 4 mm 0.76 mm A B C 1/5 W ARNING DANGER SWITCH OFF THE ENGINE BEFORE SHARPENING THE CHAIN.
18 CS-1201 NO TE • For future reference, you should keep this operator’s manual. • If this operator’s manual has become illegible through impairment or is lost, please purchase a new one from your ECHO dealer.
19 CS-1201 CS-1201 External dimentions : L × W × H mm 490 × 300 × 320 Mass : Saw without guide bar and chain, empty tanks kg 10.6 Volume : Fuel tank L 1.25 Tank for chain lubrication oil L 0.65 Fuel ( Mixture ratio ) Regular grade petrol. Minimum 89 Octane unleaded petrol is recommended.
7-2 SUEHIROCHO 1-CHOME, OHME, TOKYO 198-8711, JAPAN PHONE: 81-428-32-6118. FAX: 81-428-32-6145..
Een belangrijk punt na aankoop van elk apparaat Echo CS-1201 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Echo CS-1201 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Echo CS-1201 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Echo CS-1201 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Echo CS-1201 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Echo CS-1201 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Echo CS-1201 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Echo CS-1201 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
