Gebruiksaanwijzing /service van het product Pro-Scratch 2 van de fabrikant American Audio
Ga naar pagina of 36
Featuring: Sampling Sampling FLIP FLOP Pro-Scratch 2 ™ User Guide and Reference Manual 4295 Charter Street Los Angeles Ca. 90058 www .americandj.com Rev 02/02.
CONTENTS © American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 2 SAFETY REGULA TIONS............................................................................................................. .........3 ELECTRICAL PRECAUTIONS.
NOTE: This unit may cause interference to radio and television reception. NOTE: This CD player uses a semiconductor laser . It is recommended for use in a room at the following temperature: 41 ˚ F - .
ELECTRICAL PRECAUTIONS RISK OF ELECTRIC SHOCK DO NOT OPEN CAUTION The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.
I. Read Instructions - All the safety and operat- ing instructions should be read before the CD Player is operated. The safety and operating instructions should be saved for future reference. 2. Heed W arnings - All warnings on the CD Player and in the operating instructions should be adhered to.
Introduction: Congratulations and thank you for purchasing the American Audio ® Pro-Scratch 2™ CD player . This CD player is a representation of American Audio’s continuing commitment to produce the best and highest quality audio products possible at an affordable price.
(a) F ADER “Q” ST ART CONTROL: This feature is used in conjunction with most American Audio® and American DJ® audio mixers that also feature “Fader Q Start” control. For best results use this feature with two (2) Pro- Scratch 2™ players. Connect your Pro-Scratch 2’s as described in the set-up section of this manual.
1. Checking the Contents Be sure your Pro-Scratch 2™ was shipped with the following: 1) Pro-Scratch 2™ Professional CD player . 2) Operating instructions (this booklet). 3) One (1) set of RCA cables. 4) One (1) 1/8” mini plug. 5) W arranty card.
GENERAL FUNCTIONS AND CONTROLS A. TO P UNIT CONTROLS (FIGURE 3) 1. P ARAMETER TIME - This knob is used to adjust the parameter time value. 2. HOLD BUTT ON - This button allows you to set and lock any new parameters you set to the effects. This button will glow bright blue when the hold function is activated.
10. SAMPLER BUTTON - This is used to activate the sampler function. When this function is acti- vated a created sample will play in a continuos loop mode.
used to turn the PITCH SLIDER (33) function on and off. This button will also change the pitch percentage the PITCH SLIDER (33) will react to. The pitch percentage can be changed between 4%, 8%, 16% and 100%. 4% will allow the least amount of pitch manipulation and 100% will allow the most amount of pitch manipulation.
mixer's line input. 36. CUE MINI JACK - Connect the supplied mini- plug from CUE jack on the rear of your unit to a compatible American Audio® mixer ’s CONTROL out. This feature is only available on American Audio’s “Q” series mixers. 37.
© American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 13 GENERAL FUNCTIONS AND CONTROLS (Cont.) D. LCD DISPLA Y P ANEL (FIGURE 6) 44. PLA Y INDICA TOR - This indicator will glow when the unit is in play mode. 45. EFFECT INDICA TOR - This indicator glows when any of the nine built-in effects are selected.
BASIC OPERATIONS Figure 8: Hold down the Eject Button to remove a disc. Figure 7: When inserting a disc always hold the disc by it edges and load the disc label side up. Figure 9: T apping the reverse track button will jump back to the previous track.
3. ST ARTING PLA YBACK - Figure 1 1 Insert an audio CD as describe on page 14 ( LOADING/EJECTING DISCS ). Pressing the PLA Y/P AUSE BUTTON (17) with an audio CD inserted will imme- diately start playback. The PLA Y (44) indicator will glow as soon as playback begins.
8. SCANNING (F AST FORW ARD / F AST REVERSE) This function gives you a fast search through a disk or track. T urn the SEARCH WHEEL (5) in clockwise direction for fast forward or turn the wheel counterclockwise for fast reverse. Y ou can scan in four dif ferent for- ward and four different reverse speeds depending on how much you rotate the wheel.
Storing A Cue Point: Once you have set your CUE Point by one of the two means listed on page 16, you may store your cue point in one of the FLASH BUTTONS (8). Once you store this cue point in memory you may recall it at any time and you may even recall if the disc has been remove or power had been disconnected.
11 . EDITING A LOOP: Please note: Only the ending point of the loop may be edited. Y ou may make your loop shorter or longer . Before you can edit your seamless loop you obviously must first have created a seamless loop to edit. If you haven’t created a SEAMLESS LOOP , follow the instructions in step 10 to create a loop.
12. Using the Built In Sampler: Y our Pro-Scratch 2™ comes with an advanced built in sampler . Y ou may store up to three samples on the three FLASH BUTTON (8) (Once again please note you may only store either a CUE POINT or a SAMPLE into a FLASH BUTTON (8), not both).
Changing the Sample Parameters: Changing the sample parameters allows you to change the sample's volume and pitch. The param- eters values for both the pitch and volume settings range from 00:00 to 20:00, 00:00 being the lowest value. A higher value will increase the pitch percentage or volume.
BASIC OPERATIONS (CONT.) Figure 31 1) Press the PLA Y/P AUSE BUTTON (15) so music is playing (Figure 31). 2) Press the IN BUTTON (12) (Figure 32) at the point you want your BOP to take place. 3) Now tap the BOP BUTTON (20). It will produce a stutter ef fect as quickly as you tap on the BOP BUTTON (20).
BASIC OPERATIONS (CONT.) Figure 35 © American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 22 14. FLASH ST ART BUTT ONS (8): These button are used to store your samples and cue points. Only a sample or a cue point can be stored into each of these three banks.
© American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 23 BASIC OPERATIONS (CONT.) 17. RECALL FLASH MEMOR Y : The Pro-Scratch 2 can store all your user programmed cue points and effect parameters in to memory . These setting may be recalled at any time, even when a disc has been removed and reinserted at a later time.
PITCH ADJUSTMENTS © American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 24 1. PITCH SLIDER (33): This function will increase or decrease the tracks playback speed or "PITCH." The maximum pitch percentage manipulation in this function is +/-100%.
PITCH ADJUSTMENTS © American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 25 2. PITCH BENDING: Unlike the PITCH SLIDER (33) adjustment t his function will momentarily increase or decrease a tracks speed during playback.
PITCH ADJUSTMENTS © American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 26 PARAMETER TIME PARAMETER RATIO EJECT POWER CUE 1 2 3 4 5 6 7 8 9 0 RELOOP SINGLE LOOP REMAIN NONSTOP TOTAL ELAPSED M T S PR OGRAM LOCK KEY SYNC.
BUILT-IN EFFECTS The Pro-Scratch 2™ comes with nine built in effects. These effects can be used one at a time or you may choose to overlap the effects and use up to four at a time. The Built-in effects include Scratch, Skid, Filter , Phase, Flanger , Echo, Robot, Pan, and T rans.
© American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 28 PARAMETER TIME PARAMETER RATIO EJECT POWER CUE 1 2 3 4 5 6 7 8 9 0 RELOOP SINGLE LOOP REMAIN NONSTOP TOTAL ELAPSED M T S PR OGRAM LOCK KEY SYNC. BEAT F PITCH BPM CUE AUTO BPM OFF ON FX MIX BOP ENTER PAN FLANGER SKID PHASE FX SELECT SGL/CTN TIME RE V.
© American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 29 BUILT-IN EFFECTS Figure 54 Figure 56 HOLD BUTTON: Use the HOLD BUTT ON (2) to lock your customized param- eters. If the hold button is not activated any changes to your parameters will be momentary .
© American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 30 EFFECTS - FX MIX Figure 58 Figure 59 Figure 57 FX MIX MODE: This function allows you to use the effects to transfer from one track to another , one track to a sample, or one sample to another .
© American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 31 EFFECTS - FX MIX FX MIX - BOP CONTROL: This function allows you to engage either the SKID effect at any point of a track during normal playback. The ef fect will play out according to its parameters and then resume normal playback.
© American Audio ® - www .americandj.com - Pro-Scratch 2™ Instruction Manual Page 32 TOUCH SENSITIVE JOG WHEEL JOG WHEEL T OUCH SENSITIVITY : This function works with the SCRA TCH effects. This function allows the play and cue commands to be controled by tapping on the touch sensitive jog wheel.
FLIP-FLOP™ This feature is kind of “auto pilot”. When you are using two Pro-Scratch 2™ players and an American Audio® “Q” Deck™ mixer , you can have one player begin playback when the other ends. Y ou can “Flip -Flop™” single tracks, the entire disc, or a combination of the two.
WA RRANTY INFORMA TION: The PRO-SCRA TCH 2™ carries a TWO year (730 days) limited warranty. This warranty covers parts and labor . Please fill out the enclosed warranty card to validate your purchase and warranty . All returned service items whether under warranty or not, must be freight pre-paid and accompany a return authorization (R.
GENERAL Model: American Audio® Pro-Scratch 2™ - Professional CD Player T ype: Slot loading, digital compact disc audio player . Disc type: Standard size compact discs only (5 in / 12 cm discs) Pitch Range: Within +/- 4%, +/- 8%, +/- 16%, +/- 100% Pitch Accuracy: 0.
©American Audio® World Headquarters: 4295 Charter Street Los Angeles, CA 90058 USA T el: 323-582-3322 Fax: 323-582-331 1 W eb: www .americandj.com E-mail: info@americandj.
Een belangrijk punt na aankoop van elk apparaat American Audio Pro-Scratch 2 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen American Audio Pro-Scratch 2 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens American Audio Pro-Scratch 2 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding American Audio Pro-Scratch 2 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over American Audio Pro-Scratch 2 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van American Audio Pro-Scratch 2 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de American Audio Pro-Scratch 2 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met American Audio Pro-Scratch 2 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
