Gebruiksaanwijzing /service van het product DA 5330 W van de fabrikant Miele
Ga naar pagina of 40
Operating and installation instructions Cooker hood DA 5330 W To avoid the risk of accidents or damage to this appliance, it is essential to read these instructions before it is installed and used for the first time.
Caring for the environment ..........................................4 Warning and Safety instructions .....................................5 Modes of operation ...............................................1 1 Guide to the appliance ................
Operation with Control module DSM 400 .............................3 5 Potential free connection .........................................3 5 Connection to a light switch .......................................3 5 After Sales Service .................
Disposal of the packing material The transport and protective packing has been selected from materials which are environmentally friendly for disposal, and should be recycled. Packaging e.g. cling film, polystyrene and plastic wrappings must be kept out of the reach of babies and young children.
This appliance complies with all relevant local and national safety requirements. Inappropriate use can, however, lead to personal injury and damage to property. To avoid the risk of accidents and damage to the appliance, please read these instructions carefully before using it for the first time.
Technical safety ~ Before installation, check the cooker hood for visible signs of damage. Under no circumstances should you use a damaged appliance. A damaged appliance is dangerous.
~ Do not connect the appliance to the mains electricity supply by a multi-socket unit or an extension lead. Extension leads do not guarantee the required safety of the appliance (e.g. danger of overheating). ~ This appliance must not be used in a non-stationary location (e.
In order to ensure safe operation, and to prevent gases given off by the heating appliances from being drawn back into the room when the cooker hood and the heater are in operation simultaneously, an underpressure in the room of 0.04 mbar (4 pa) is the maximum permissible.
Correct use ~ Never use an open flame beneath the cooker hood. To avoid the danger of fire, do not flambé or grill over an open flame under the cooker hood. When switched on, the cooker hood could draw flames into the filter. Fat particles drawn into the cooker hood present a fire hazard.
Correct installation ~ Refer to the cooker or hob manufacturer's instructions as to whether a cooker hood may be operated above the cooker/hob. ~ The minimum safety distances between the top of t.
The cooker hood works with . . . air extraction: The air is drawn in, cleaned by the grease filters and directed outside. If the on-site ventilation system is not already fitted with non-return flaps , then the two non-return flaps supplied with the appliance must be fitted in the exhaust sockets in the motor units.
Guide to the appliance 12.
a Telescopic extension piece b Tower c Canopy d Hob lighting e Recirculation grille (only for recirculation mode) f Controls The two sides of the cooker hood can be operated independently of one another.
Con | ctivity This cooker hood is communication enabled. The communication modules XKM 2000 DA a , available as an optional extra, enable the operation of the cooker hood to be automatically controlled by the operating status of a Miele electric hob with onset controls.
The two sides of the cooker hood can be operated independently of one another. To switch a fan on ^ Press the On/Off control. The fan selected will come on at power level lI. The indicator lamp will come on. To select a power level ^ Use the – / + controls to select the power level required.
The indicator lamps for fan power levels I and IV will flash if the automatic switch-off for the Intensive setting is not activated. ^ Press the + control to activate auto - matic switch-off. The indicator lamps for fan power levels I and IV will now light up constantly.
To switch the hob lighting on The hob lighting can be switched on and off independently of the fan. ^ Briefly press the lighting control to switch on the hob lighting. The indicator lamp will come on. The hob lighting will switch on at maximum brightness.
^ To do this, while the fan is switched on, press and hold the grease filter control until only the first of the – / + indicator lamps is flashing. ^ The grease filter counter on the other set of controls must also be reset in the same way, even if this operating hours counter has not yet reached its maximum.
^ Press the run-on option control and the grease filter control at the same time. The indicator lamp for the grease filter control and one of the – / + indicator lamps will flash.
^ Use the – / + controls to select the desired time. ^ Confirm the selection by pressing the charcoal filter control. All the indicator lamps will go out. If you do not confirm your selection within 4 minutes, the cooker hood will automatically revert to the "old" data.
A range of Miele branded cleaning and conditioning products is available to order from Miele (see back page for details) or via the internet at www.miele-shop.com. , Before any cleaning or maintenance work is carried out, disconnect the cooker hood from the mains supply.
Important for appliances with lacquered housing (special order finish) It is very difficult to clean this type of surface without causing minor marks to the surface material. This can become particularly noticeable with darker colours and if there is halogen lighting in the kitchen.
Cleaning the grease filters by hand ^ Clean the filters with a soft nylon brush in a mild solution of hot water and a little washing-up liquid. Do not use "neat" washing up liquid. Do not use: – cleaning agents containing descaling agents, – powder cleaners, cream cleaners or abrasive all-purpose cleaning agents, – oven sprays.
Fitting and replacing the charcoal filters If the cooker hood is connected for recirculation, a charcoal filter must be inserted into each of the charcoal filter frames above the grease filters in either side of the canopy, in addition to the grease filters.
Changing a halogen lamp ^ Before any cleaning or maintenance work, disconnect the cooker hood from the mains supply. Please note that this appliance has two electrical connections, and both have to be disconnected for cleaning or maintenance work. , Exercise caution when changing halogen lamps.
1) Extraction 2) Recirculation 3) Ventilation grille positioned at the top for recirculation 4) and 5) The shaded areas represent the wall or ceiling area for the vent cut-outs and for fitting the connection sockets. For recirculation mode, you only require cut-out area 4) and a connection socket for each tower.
Safety distance between hob and cooker hood (S) When planning the installation height of your cooker hood, the minimum safety distance between the top of a cooker or hob and the bottom of the cooker h.
Installation accessories Installation 28.
a 6 protective sheets for use when fitting the towers. b 2 exhaust connections for exhaust ducting C 150 mm c 2 reducing collars for C 125 mm exhaust ducting d 2 non-return valves for fitting into the exhaust connections on the motor units (for extraction mode only) e Telescopic wall brackets for securing the cooker hood to the wall.
Before installation, it is important to read the information given on the following pages as well as the "Appliance dimensions" and the "Warning and Safety instructions" at the beginning of this booklet.
Important: To avoid the danger of toxic fumes, please observe the Warning and Safety instructions. This is especially crucial when using the cooker hood at the same time as another heating appliance which relies on air from the same room. The cooker hood should be installed according to local building regulations.
Condensate trap (optional accessory) In addition to insulating the exhaust ducting, we recommend that two suitable condensate traps are also installed to collect and evaporate any condensate which may occur. Condensate traps are available for C 125 mm or C 150 mm ducting.
Silencer (optional accessory) To achieve even further reductions in noise levels, special silencers can be fitted in the ducting system. ...with air extraction: The silencers not only reduce noise from the fan, but also sounds from outside (e.g. traffic noise).
All electrical work should be undertaken by a suitably qualified and competent person in strict accordance with current national and local safety regulations (BS 7671 in the UK). Installation, repairs and other work by unqualified persons could be dangerous, for which the manufacturer cannot be held liable.
The Miele DSM 400 control module can be used to combine the cooker hood with other components. As the right and left hand sides of the hood work independently of one another, two control modules are required for this. Potential free connection This can be used to operate a further appliance via the On/Off button s on the cooker hood.
In the event of a fault which you cannot correct yourself, or if the appliance is under guarantee, please contact: – Your Miele Dealer / Chartered Agent or – The Miele Service Department (see back cover for address). When contacting your Dealer or Miele, please quote the model and serial number of your appliance.
Total connected load ..........5 2 0W – Fan motors .............2x2 0 0W – Hob lighting .............6x2 0W Voltage ................. A C2 3 0V Frequency .................. 5 0H z Fuse rating ...................1 3A Electrical cable length .......
38.
39.
Alteration rights reserved / 3011 M.-Nr. 09 203 290 / 00.
Een belangrijk punt na aankoop van elk apparaat Miele DA 5330 W (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Miele DA 5330 W heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Miele DA 5330 W vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Miele DA 5330 W leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Miele DA 5330 W krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Miele DA 5330 W bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Miele DA 5330 W kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Miele DA 5330 W . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
