Gebruiksaanwijzing /service van het product RFSDV34RFPAU van de fabrikant Raypak
Ga naar pagina of 27
RAYPAK VERMONT RFSDV34 FREESTANDING GAS LOG FIRE Installation and Operating Instructions For Models RFSDV34RFNAU (Natural Gas) & RFSDV34RFPAU (Propane) Page 1 of 27.
CONTENTS Part 1: For Your Safety Part 2: Installation Instructions • Start Up Recommendations • Locating The Fireplace • Clearance to Combustibles • Fireplace Dimensions • Gas Specifications.
Part 7: Conversion • Gas Type Conversion Instruction Part 8: Wiring Diagram • Wiring Diagram Part 9: Warranty Page 3 of 27.
Part 1: For Your Safety For your safety do not operate this appliance before readi ng this instruction book. Warning: Improper installation, adjustm ent, alt eration, service or maintenance can cause injury or pr operty damage.
Part 2: Installation Instructions This gas fireplace must be installed by a qualified installer in accordance with AS5601 and all relevant local building codes.
IMPORTANT: PLEASE READ THE FOLLOWING CAREFULLY Remove any plastic from trim parts before turning the appliance on. It is normal for fireplaces fabricated of steel to give o ff some expansion and/or contraction noises during t he start up or cool down cycle.
DIMENSION RFSDV34 A 667mm B 800mm C 492mm D 762mm E 254mm F 394mm G 114mm H 667mm I 333mm J 495mm K 162mm Page 7 of 27.
Gas Specifications Model Gas Type Gas Control Min. MJ/h Input Max. MJ/h Input RFSDV34RFN Natural Radio Freq. 22 32 RFSDV34RFP Propane Radio Freq. 24 32 Gas Inlet and Burner Pressures Natural Gas ULPG Inlet Minimum 1.1 kPa 2.75 kPa Inlet Maximum 3.50 kPa 3.
Note: When making the gas connection to the appliance inlet fitting, hold the 10mm 3/8” BSP fitting with a s panner when tightening the gas inlet pipe compression nut. For Propane installations an approved gas regulator must be fitted in accordance with AS5601.
Part 3: General Flue Installation Underside of gas cowl must be at least 500mm above highest point of the roof. This appliance is approved for an installation with a maximum flue height of 12m and a minimum flue height of 3m. Suspend a plumbline from the ceiling to the centre of the flue spigot.
Part 4: Operating Instructions NOTE: Carbon deposits maybe present on the glass and logs. This is normal and must be cleaned when the heater is serviced or the glass door is cleaned.
glass and causes lint, dust and other air-borne particles to cling. Initial paint curing may also deposit a slight film on the glass. Clean the glass two or three ti mes with a non-ammonia based household cleaner and warm water. (We recomm end gas fireplace glass cleaner.
Flame and Temperature Adjustment The appliance is fitted with the Honeywe ll Radio Frequency control valve and all adjustments are performed with t he use of a remote controller. See instructions packaged with the Remote Controller or refer to page 16 in this manual for operating instructions.
• DO NOT use any phone in the building. • IMMEDIATELY call you gas supplier from a neighbour’s phone or a mobile phone outside the build ing. Follow the gas suppliers instructions. • IF YOU CANNOT CONTACT YOU GAS SUPPLIER CALL THE FIRE BRIGADE.
13. For the RN/RP models turn the remote control ON/OFF switch to the ON position or set the thermostat to the desired setting. 14. Turn on electrical supply. To Turn Off the Heater 1. Turn the remote control ON/OFF switch to OFF or set the thermostat to the lowest setting.
remote control within 30 seconds. The LED will blink indicating the remote control will now work with the receiver valve. If the switch continues in the REMOTE position, the remote control will now control the main valve, flame modul ation level and fan control.
Fig. 7 Transmitter diagram Delay Timer Mode The shut off delay timer maximum setting is 2 hours and minimum setting is zero minutes. To change the timer le vel, press the timer key, then the arrow key. Each key press changes the setting by 10 minutes.
To Change Batteries 1. Remove cover on backside of the remote control. Install 3 AAA as shown on the cover and then re-attach the cover. 2. Once OPERATION steps 1 to 3 are completed, the receiver/valve and remote control are ready.
If an error code 8 is observed while performing the testing, complete the following: 1. Confirm that the gas valve is not in the REMOTE mode. • If the valve is producing error code 8 while in the REMOTE mode, the valve is defective and should be replaced.
Troubleshooting the Gas Control System Comfort Valve System Control Seque nce of Operation with Remote Control Local Path On Path Auto Path Move switch from manual to remote. Press any key on remote control If the manual switch is set to remote, press the mode button to display ON.
Part 6 Replacement Parts List Insert replacement parts list and parts drawing here. Part 7 Conversion Instructions 1. Disconnect power to the unit and shut off the gas supply. 2. Remove the window frame a ssembly. (see the Window Frame Assembly section) 3.
Part 8 Wiring Diagram A N 240V A C Te r m i n a l B l o c k Tr a n s f o r m er 240V AC - 110V AC 2A (50V A) Fuse - 3 Amp 240V A C 50 Hz Main Heater Supply Speed C on trol High Limit Fan RFSDV34 GAS L.
Page 23 of 27.
Page 24 of 27.
Page 25 of 27.
Part 9 Warranty RAYPAK RFSDV34RFN & RFSDV34RFP FREESTANDING GAS LOG FIRE WARANTY - AUSTRALIA ONLY – Rheem Australia * w ill: a) Repair o r, if necessary replace any Ra ypak RFSDV34 Freestan ding.
RAYPAK MAJESTIC RFSDV34RFNAU AND RFSD34RFPAU WARRANTY - AUSTRALIA ONLY – WARRANTY CON DITIONS 1. This warranty is appli cable only to the RFSDV34RFN and the RFSDV34RFP gas log fires manufactured from August 2005 2.
Een belangrijk punt na aankoop van elk apparaat Raypak RFSDV34RFPAU (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Raypak RFSDV34RFPAU heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Raypak RFSDV34RFPAU vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Raypak RFSDV34RFPAU leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Raypak RFSDV34RFPAU krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Raypak RFSDV34RFPAU bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Raypak RFSDV34RFPAU kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Raypak RFSDV34RFPAU . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
