Gebruiksaanwijzing /service van het product RK-65K van de fabrikant SoundCraft
Ga naar pagina of 35
Radio Key ® RK-65K RK-65KS with RK100M instructions STAND ALONE PROXIMITY ACCESS CONTROL SYSTEM with DYNASCAN ® TECHNOLOGY* 3321732 Operating Guide Rev . C A Division of Soundcraft, Inc. 20301 Nordhoff Street Chatsworth, CA 9131 1 Phone: 818-882-0020 • Fax: 818-882-7052 Website: www .
COPYRIGHT © 2007 SOUNDCRAFT , INC. V060107 6451.
Radio Key ® RK-65K/RK-65KS Operating Guide T able of Contents Introduction .........................................................................1 Ordering T ransponders ...................................................... 3 Programming Radio Key ® RK-65K/RK-65KS .
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 1 INTRODUCTION The Radio Key ® RK-65K is a programmable single-door access control system which controls access for up to 65,000 users.
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 2 Figure 1 - Radio Key ® RK-65K & RK-65KS Units NOTE: All references to RK-65K also apply to the RK-65KS.
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 3 ORDERING TRANSPONDERS The Radio Key ® RK-65K works with Secura Key RKCM-02 molded (clamshell) cards, RKCI-02 ISO-standard cards and RKKT -02 key ring tags. Card Format 303 and Format 201 can be used.
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 4 PROGRAMMING RADIO KEY ® RK-65K When the RK-65K is fi rst powered up, the LED will be fl ashing Red and Green. Present a card to the unit to set the Facility Code and the fl ashing will end in approximately 10 seconds.
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 5 PROGRAMMING RADIO KEY ® 100M Radio Key ® T ransponders (Key T ags and Cards) are pre-en- coded and engraved at the factory with unique T ransponder ID numbers. Because these numbers are unique, Facility Codes (Site Codes) are not required.
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 6 THE RK-HHP HANDHELD PROGRAMMER AND THE RK-PD1 PROGRAM DECK Note: The RK-PD1 or the RK-HHP is required to program the reader .
PROGRAMMING STEPS T o program the Radio Key ® RK-65K, you must fi rst enter the program mode as described in the next section below . Once in the program mode, the LED will blink amber as an indicator .
(Password) (ENTER) T o Enter Program Mode (RK65K/RK100M): Using your programmer , enter your password and then press “ENTER”. (All new units are pre-programmed with the password 12345.) The LED will fl ash amber to show that the unit is in Program Mode.
(New Password - 54321) (Re-type New Password - 54321) (ENTER) (THRU) (THRU) Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 9 + 5 + 4 + 3 + 2 + 1 + + 5 + 4 + 3 + 2 + 1 + Lost or forgotten Password (RK65K/RK100M) If the password is lost or forgotten, it can be restored to the factory default (12345).
(User ID Number 12) (ADD) (ENTER) (MODE) (ENTER) (Mode Number 9) Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 10 Y ou can also place a reader in this mode by entering the Program Mode (see page 8) then pressing Mode followed by “9” followed by Enter .
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 1 1 (Ending User ID Number 10) (ADD) (ENTER) (Starting User No. 1) (THRU) (User ID Number 12) (ENTER) (VOID) Add A Series Of T ransponders T o The System (RK65K): Place the unit into the Program mode ( see Page 8).
(SET TIMER) (ENTER) (15 Seconds) Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 12 (Ending User ID Number 10) (ENTER) (VOID) (THRU) (Starting User No. 1) Delete A Series Of T ransponders From The System (RK65K): Place the unit in the Program Mode (see Page 8).
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 13 (SET TIMER) (ENTER) (2 Hours, 45 Minutes) (THRU) For longer latch times it may be easier to set the timer with hour: minute notation.
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 14 Set the Operating Mode (RK65K/RK100M): The Radio Key ® RK-65K may be put into any of four operational modes.
(MODE) (ENTER) (Mode Number 1) Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 15 (Mode Number 2) (MODE) (ENTER) T o set the Operating Mode, put the unit into the Program mode, (See Page 8) . Pr e ss M OD E , t h en p re s s e i th e r “ 1” , “2 ” , “ 3 ”, o r “ 4 ”.
(SET TIMER) (ENTER) (THRU) (SET TIMER) (ENTER) (ADD) Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 16 (SET TIMER) (ENTER) (VOID) Enable Timed Antipassback (RK65K): Place the unit in the Program Mode ( see Page 8) . Pr e ss S ET TIMER, then press ADD, fi nally press ENTER.
(ENTER) (THRU) (THRU) Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 17 Confi gure the Relay (RK65K/RK100M) The relay is set at the factory to be normally open and to close upon presentation of a valid transponder or upon activation of the remote open (Request to Exit) input.
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 18 Using the RK-65K as a Wiegand Output Reader (RK65K/RK100M) The RK-65K can be connected to a multidoor access control system (such as the Secura Key SK-ACP) using the Wiegand output.
(ENTER) (THRU) (THRU) (Input No. 2) Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 19 For example, to program the input for LED control, the following sequence would be followed: + + .
Radio Key ® R K - 6 5 K O p e r a ti ng Gu id e Secura Key 20 Remote Open (Request to Exit) Input (RK65K/RK100M) When the Remote open input is activated, the relay will activate. When the remote open input is deactivated, the relay will return to the inactive state after the latch timer times out.
(MODE) (ENTER) (Mode Number 5) Radio Key ® R K - 6 5 K O p e r a t i n g G u i d e Secura Key 21 (MODE) (ENTER) (Mode Number 6) CONVERTING TO RK100M MODE The RK100M has been replaced by the new RK-65K. The RK100M was designed to read randomly numbered cards and tags without facility codes (RKCM-01, RKKT -01).
ADDING AND DELETING USERS: RADIO KEY ® 100M Radio Key ® T ransponders (Key T ags and Cards) are pre- encoded and engraved at the factory with unique T ransponder ID numbers. Because these numbers are unique, Facility Codes (Site Codes) are not required.
(User ID Number 12) (ADD) (ENTER) Add a T ransponder (Key T ag or Card) to the System: Put the unit into the Program mode (See Page 8). Press ADD, then press the sequence of digits representing the desired User ID Number (1-100), then press ENTER. Hold the T ransponder near the Unit.
(User ID Number 12) (ADD) (ENTER) (ID Number 995) (THRU) Add a T ransponder by Entering the T ransponder ID: Instead of presenting the transponder , you can also use the Programmer to enter the T ransponder ID number: Put the unit into the Program mode ( See Page 8).
(Ending User ID Number 10) (ADD) (ENTER) (Starting User No. 1) (THRU) (THRU) Secura Key 25 (VOID) (ENTER) (User ID Number 12) Radio Key ® R K - 6 5 K O p e r a t i n g G ui d e starting User ID Number to the unit. Press THRU. Then press the sequence of digits representing the desired ending User ID Number .
(Ending User ID Number 10) (ENTER) (Starting User No. 1) (VOID) (THRU) Delete a Range of T ransponders from System: Put the unit into the Program mode ( See Page 8). P r es s VOID, then press the sequence of digits representing the desired starting User ID Number .
(ID Number 995) (VOID) (ENTER) (THRU) Delete a T ransponder by Entering T ransponder ID: Put the unit into the Program mode (See Page 8). P r es s VOID. Press THRU, then press the sequence of digits representing the ID number printed on the T ransponder .
W ARRANTY (U.S. and Canadian) “This product is warranted against defects in materials and workmanship for life. Secura Key shall, at its option, either replace or repair this product, if returned to us freight prepaid within the warranty period.
SPECIFICA TIONS Models RK-65K RK-65KS Physical Depth 0.60” (1.52 cm) 0.84” (2.13 cm) Width 1.60” (4.06 cm) 3.20” (8.12 cm) Height 3.50” (8.89 cm) 4.50 (1 1.43 cm) Weight 2.88 oz. (81.65 gm) 6.67 oz. (189.15 gm) Material ABS Lexan ® Color Black Beige Power Requirements 5-14 VDC, 90 mA Max.
Environment Ambient T emperature -40° to +70° C (-40° to +158° F) Humidity 0% to 100% (non-condensing) Operational Reading Distance Molded Card: Up to 6” (15.
Radio Key ® R K - 6 5 K O p e r a t i n g G u i d e Secura Key 31 FCC ID: NNHRK-100M INSTRUCTION TO THE USER This equipment has been tested and found to comply with the limits for a class B digital device, pursuant to part 15 of the FCC Rules.
A Division of Soundcraft, Inc. 20301 Nordhoff Street Chatsworth, CA 9131 1 Phone: 818-882-0020 • Fax: 818-882-7052 TOLL FREE (800) 891-0020 Website: www .
Een belangrijk punt na aankoop van elk apparaat SoundCraft RK-65K (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen SoundCraft RK-65K heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens SoundCraft RK-65K vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding SoundCraft RK-65K leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over SoundCraft RK-65K krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van SoundCraft RK-65K bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de SoundCraft RK-65K kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met SoundCraft RK-65K . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
