Gebruiksaanwijzing /service van het product 8627 BS van de fabrikant Stovax
Ga naar pagina of 28
Riva Nemos Balanced Flue Convector Fire With upgradeable control valve Instructions for Use, Installation and Servicing For use in GB, IE (Great Britain and Eire) IMPORTANT Do not attempt to burn rubbish in this appliance. This appliance must only be operated with the glass door secured firmly in position.
2 CONTENTS COVERING THE FOLLOWING MODELS 8627 MA P8627 MA 8627 BS P8627 BS PAGE APPLIANCE COMMISSIONING CHECKLIST 3 USER INSTRUCTIONS 4 INSTALLATION INSTRUCTIONS 8 Technical Specifications 8 Site Requ.
3 FLUE CHECK PASS FAIL 1. Flue is correct for appliance 2. Flue flow test N/A 3. Spillage test N/A GAS CHECK 1. Gas soundness & let by test 2. Standing pressure test mb 3. Appliance working pressure (on High Setting) mb NB All other gas appliances must be operating on full 4.
4 USER INSTRUCTIONS 1. GENERAL 1.1 A competent person must carry out installation and servicing. 1.2 In all correspondence, please quote the appliance type and serial number, which can be found on the databadge located on a plate under the control valve.
5 USER INSTRUCTIONS 5. CLEANING THE NEMOS ENSURE THE APPLIANCE IS COLD BEFORE PROCEEDING. 5.1 The outside casing of the Nemos should be cleaned using a damp cloth. If you have a stainless steel door version, it should be cleaned using a stainless steel cleaner.
7 AR1197 6.6 Place log F resting on the rear tray and leaning forward to locate in the recess in log E. See diagram 8. AR1198 8 6.7 Place log G at the front of the fire between logs D and E. DO NOT PLACE THIS LOG ON THE BURNER. IT IS ONLY TO FILL THE GAP BETWEEN LOGS D AND E.
7 USER INSTRUCTIONS 10 AR1120 6.9 Ensure that the fibreglass seal on the back of the glass frame is intact then hook the location tabs over the hooks on the top of the firebox. Replace the nine screws working from the top down. Tighten the screws evenly.
8 INSTALLATION INSTRUCTIONS TECHNICAL SPECIFICATION COVERING THE FOLLOWING MODELS: 8627 MA P8627 MA 8627 BS P8627 BS PACKING CHECKLIST Qty Description 1 Nemos stove assembly 1 Ceramic back panel * 1 C.
9 INSTALLATION INSTRUCTIONS SITE REQUIREMENTS 1. FLUE AND CHIMNEY REQUIREMENTS NOTE: This appliance can only be installed in conjunction with the flue supplied. 1.1 The flue must be sited in accordance with all local and national regulations and current rules in force.
10 1C AR1673 2.1 TOP FLUE UP & OUT KIT (8534/8534AN) Vertical from the top of the appliance then horizontally out. (See diagram 1A). The basic kit comprises: 1 x 200mm vertical length 1 x 500mm te.
11 INSTALLATION INSTRUCTIONS SITE REQUIREMENTS 4. VENTILATION 5. APPLIANCE LOCATION 4.1 This appliance requires no additional ventilation. 5.1 It is not necessary to site the appliance on a non- combustible floor. However, for practical reasons, the floor should be flat and solid to allow the appliance to be levelled and secured in place.
12 IF THE APPLIANCE IS EXTINGUISHED OR GOES OUT IN USE, WAIT 3 MINUTES BEFORE ATTEMPTING TO RELIGHT THE APPLIANCE. 3. INSTALLATION OF THE APPLIANCE NOTE: THERE IS AN OPTIONAL CONVECTION FAN KIT AVAILABLE CODE No.
3.3 Remove the lower front panel by gripping the top tag and pulling gently upwards and out. Locate the two bolts securing the appliance to the crate base and remove. See diagram 3. AR1290/1 3 3.4 Gently remove the appliance from the crate and place into its intended position.
3.9 Before any flue pipe is attached to the appliance, unwrap the decorative cast iron collar and locate over the outer flue spigot ensuring that the location lug locates in the notch at the rear of the hole.
3.16 It is now necessary to connect the gas supply to the appliance. The gas supply may enter through the floor directly under the appliance or through the knockout panel in the rear RH corner of the outer casing. In both instances, a preformed pipe is ready fitted and connection should be made to the compression fitting on the end of this pipe.
16 4. ARRANGEMENT OF FUEL BED COMPONENTS ADVICE ON HANDLING AND DISPOSAL OF FIRE CERAMICS The fuel effect and side panels in this appliance are made from Refractory Ceramic Fibre (RCF), a material which is commonly used for this application.
17 INSTALLATION INSTRUCTIONS INSTALLATION AR1198 8 4.7 Place log G at the front of the fire between logs D and E. DO NOT PLACE THIS LOG ON THE BURNER. IT IS ONLY TO FILL THE GAP BETWEEN LOGS D AND E. The charred effect should face the rear of the fire.
18 6. LIGHTING THE NEMOS 6.1 Locate the control valve on the appliance. There are two control knobs on the valve, the right hand knob controls the pilot ignition and the left hand knob controls the main burner.
19 SERVICING INSTRUCTIO NS SERVICING / FAULT FINDING CHARTS IGNITION FUNCTIONAL CHECK 1 PILOT WILL NOT LIGHT Ensure there is no debris around the pilot assembly, (e.g. soot, etc.) which could short the spark, clean the area. Operate the valve. Is there a spark? Consult User Instructions and retry.
20 SERVICING INSTRUCTIO NS FAULT FINDING CHARTS PILOT WILL NOT STAY LIT OR FIRE GOES OUT IN USE Ensure there is no debris around the pilot assembly, (e.g. soot etc.) Check for fluff in the pilot aeration hole. See diagram 5 in Replacing Parts, section 2.
21 2.3 Remove the ceramic logs and the embers. 2.4 Carefully slide the ceramic sides forward and store safely. See diagram 3. 3 AR0759 2.5 Remove the screws from the log support. The feed pipe nut is now visible between the burner and the angled base of the firebox.
22 3. PILOT UNIT The pilot assembly consists of four components, which can be individually changed, these are: 1) Pilot burner bracket. 2) Pilot injector 3) E l e c t r od e 4) Thermocouple. 3.1 Open the front door of the appliance and turn off the gas supply at the isolating device.
23 d) Remove the external feed pipe from the brass fitting. See diagram 8 arrow B. e) Remove the 2 screws fixing the valve bracket to the base of the appliance. f) Gently slide the gas valve and bracket forward and disconnect the thermocouple from the rear of the gas valve.
24 6.3 Remove the two screws retaining the valve bracket. See diagram 12. 12 AR0822 6.4 Remove the ignition lead as described in section 4. 6.5 The valve should now be able to be eased forward so the pipes and thermocouple can be removed from the rear of the valve.
12. SHORT SPARES LIST COMPONENT NG LPG PILOT INJECTOR PI0026 PI0015 MAIN INJECTOR IN0029 IN0051 AERATION PLATE NATURAL GAS G20 GZ2025 BURNER UNIT GZ3964 AERATION PLATE LPG G30 G31 GZ3865 GZ2003 BURNER.
26 SERVICE RECORDS 1ST SERVICE 2ND SERVICE Date of Service: . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . Date of Service: ................................. Next Service due: ............................... N e x t S e r v i c e d u e : .
27.
Gazco Limited, Osprey Road, Sowton Industrial Estate, Exeter, Devon, England EX2 7JG Tel: (01392) 261999 Fax: (01392) 444148 E-mail: info@gazco.com A member of the Stovax Group.
Een belangrijk punt na aankoop van elk apparaat Stovax 8627 BS (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Stovax 8627 BS heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Stovax 8627 BS vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Stovax 8627 BS leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Stovax 8627 BS krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Stovax 8627 BS bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Stovax 8627 BS kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Stovax 8627 BS . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
