Gebruiksaanwijzing /service van het product GT-50 van de fabrikant Boston Acoustics
Ga naar pagina of 19
GT-50 5-Channel, High-Curr ent/High-Power Amplifier.
2 T able of Contents Parts List 3 Features and Specifications 3 Control Functions 4 Control functions (cont.) 5 Control functions (cont.) 6 Mechanical Functions 6 Control cover r emoval and reinstallation 6 Multi-position mounting feet 6 Mechanical functions (cont.
Included Hardwar e (1) owner’ s manual (1) female quick-connect terminal for remote input (1) 2mm hex wrench (for speaker input) (1) 3mm hex wrench (for power input) (6) mounting screws 3 Parts List GT -50 Specifications 14.4VDC Power Multi-Channel Power @ 4 Ω 4x55W , 1x250W Multi-Channel Power @ 2 Ω 4x85W , 1x350W Mixed Op.
4 Contr ol Functions FRONT RCA Inputs RCA cables marked “FRONT” from head unit or fr om other line level device should be connected here. Use both inputs (L & R) for ster eo. FRONT , REAR, and SUBWOOFER Remote Inputs Use the supplied FEMALE quick connector to connect the REMOTE trigger lead from the head unit to the amplifier .
FRONT and REAR “Q” Controls “Q” Control is active when the highpass cr ossover is engaged and is centered on the selected crossover point. The range of operation is 0.7–1.2. REAR RCA Inputs RCA cables marked “REAR” from head unit or other line level device should be connected here.
6 Mechanical Functions Recessed RCA Inputs The input jacks are r ecessed into the body of the amplifier to provide clear- ance in tight mounting locations. Control Cover Removal and Reinstallation The cover panel is secured with two (2) captive coin-slotted scr ews.
Mechanical Functions (cont.) V ents (Side and Rear) The cooling vents must be kept clear of obstructions once the amplifier is installed. Failure to do this could lead to prematur e thermal shutdown or amplifier failure. Amplifier Linking The design of the side panels enables multiple amplifiers to be used together without additional hardwar e.
8 Before Y ou Install Before you install the unit, disconnect the negative (–) battery cable in the engine compartment of the vehi- cle. Doing so will prevent damage to both the electrical system of the vehicle and the amplifier during installation.
13mm ( 1 / 2 ”) 225mm (8 7 / 8 ”) SUBWOOFER OUTPUT HIGHPASS OFF ON 5 0.2 V INPUT SENSITIVITY 2.6 20 350 Hz 200 REMOTE POWER B+ B+ POWER GND GND FUSE 3 x 30A FRONT SPEAKER OUTPUT L R REAR SPEAKER OUTPUT L R 12dB 24dB OFF LOWPASS 50 350 Hz 200 NON PRINTABLE AREA REAR INPUT STEREO MONO L+R HIGHPASS OFF ON 5 0.
10 Passenger and T runk Compartment Mounting If the amplifier is mounted under a seat, be sure that the vents do not become blocked. Do not allow seat padding or other obstructive material to press down on the amplifier . All Boston GT amplifiers have top panel controls.
FRONT SPEAKER OUTPUT L R REAR SPEAKER OUTPUT L R Power/B+ and Power/GND Connection Strip approximately 5 / 8 " (16mm) of insulation. The positive (+) power wir e is installed into the amplifier terminal marked “B+.” The negative (–) wire is installed into the terminal marked “GND.
12 Mono Subwoofer Operation Connect either a 2-ohm or 4-ohm subwoofer to a single (+) and (-) terminal (see System A, page 16). When using two (2) subwoofers, each subwoofer should be a minimum 4-ohm [or higher] impedance, (see System B, page 17). W ARNING! Subwoofer impedance must not fall below 2 ohms when in MONO mode.
13 Setup T uning—Full-Range Speakers (cont.) 4) Head Unit The head unit should have all controls such as bass, tr eble, balance, and fader set to the flat or centered position.
14 8) FRONT and REAR “Q” Controls Once the FRONT highpass crossover point has been determined, use the FRONT “Q” control to incr ease the bass information centered ar ound the crossover point.
15 5) SUBWOOFER Sensitivity Control Tu rn controls all the way counter clockwise (minimum position). In this position, the amplifier will be less sen- sitive to the input signal from the head unit. Slowly r otate this control clockwise until maximum undistorted playing level is heard fr om the subwoofers.
16 System Examples SYSTEM A—Front, Rear , and Single 2 Ω Subwoofer (2 Ω load) L R L R ON ON SAFE SAF E 6 . 5 L F 6 . 5 L F fuse to + battery terminal to gr ound fuse to + battery terminal to ground 12.
17 SYSTEM B—Front, Rear , and Dual 4 Ω Subwoofers (2 Ω load) with Discrete Subwoofer Input L R L R ON ON SAFE SAF E 6 . 5 L F 6 . 5 L F fuse to + battery terminal to gr ound fuse to + battery terminal to ground 6 .
18 Amplifier T r oubleshooting Guide Status LEDs on Amplifier not Lit — Head Unit (Sour ce) T urned “ON” V erify Remote turn-on wire fr om source to amplifier has pr oper voltage Power (B+) c.
19 Contact and W arranty Information 300 J ubilee Drive Pe a b o d y, MA 0 1 960 U.S.A. (978) 538-5000 Boston, Boston Acoustics, and the Boston logo are r egister ed trademarks of Boston Acoustics, Inc. © 2003 Boston Acoustics, Inc. All rights reserved.
Een belangrijk punt na aankoop van elk apparaat Boston Acoustics GT-50 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Boston Acoustics GT-50 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Boston Acoustics GT-50 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Boston Acoustics GT-50 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Boston Acoustics GT-50 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Boston Acoustics GT-50 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Boston Acoustics GT-50 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Boston Acoustics GT-50 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
