Gebruiksaanwijzing /service van het product IE40890 van de fabrikant Image
Ga naar pagina of 18
QUESTIONS? As a manufacturer , we are com- mitted to providing complete customer satisfaction. If you have questions, or find that there are missing or damaged parts, we will guarantee you complete satisfaction through direct assis- tance from our factory .
2 W arning Decal Placement . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 2 Important Precautions . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
3 W ARNING: Before beginning this or any exercise program, consult your physician. This is especially important for persons over the age of 35 or persons with pre-existing health problems. Read all instructions before using. ICON assumes no responsibility for personal injury or property damage sustained by or through the use of this product.
4 Weight Carriage Weight T ube High Pulley Station Low Pulley Station Lat Bar Weight Rest Safety Spotter Curl Pad Right Side Left Side Note: The terms Òright sideÓ and Òleft sideÓ are determined relative to a person sitting on the bench; they do not correspond to right and left on the drawings in this manual.
5 Part Identification ChartÑModel No. IMBE40890 R0999A M10 Nylon Locknut (1 1)Ð29 M8 Nylon Locknut (13)Ð2 M6 W asher (30)Ð4 M6 x 16mm Screw (3)Ð6 M8 x 64mm Bolt (43)Ð1 M6 x 38mm Screw (4)Ð4 Pro.
6 1. Before beginning assembly , make sure that you understand the information in the box above. Note: Some of the parts described in the assem- bly steps may be pre-assembled. Press a 2Ó Square Inner Cap (17) into the indicated end of the Right Stabilizer (26).
3. Align the holes in a 4-hole Support Plate (16) with the holes in the Right Upright (2). Insert four M10 x 72mm Bolts (68) into the Support Plate and the Right Upright. Make sure that the Bolts are inserted from the direction shown. Align the holes in another 4-hole Support Plate (16) with the holes in the Left Upright (1).
8 4. Snap a Carriage Bushing (56) into the Weight Stop (53). Slide both parts onto the Rear Upright (9), mak- ing sure that the Carriage Bushing (56) is on top. Attach the parts to the indicated hole in the Rear Upright with an M8 x 68mm Bolt (60) and an M8 Nylon Locknut (13).
9 7. The Upper Cable (45) was attached to the Weight Carriage in step 5. Wrap the Upper Cable around a Pulley (35) in the direction shown. Attach the Pulley (35) and a Cable T rap (61) to the indicated hole in the T op Frame (7) with an M10 x 108mm Bolt (34), a 15.
10 1 1. Locate the Lower Cable (39) and note that it has a ball/loop on one end and a loop only on the other . See drawing 1 1a. Route the end of the Lower Cable with the loop through the cable guide on the outside of the Right Upright (2). See drawing 1 1.
11 13. Insert two M10 x 68mm Bolts (33) into the 2-hole Support Plate (70), the Front Leg (19), and the brack- et on the Bench Frame (5) as shown. T ighten an M10 Nylon Locknut (1 1) onto each Bolt. 13 33 11 11 5 70 19 14. Align the bracket on the Bench Frame (5) with the holes in the center of the Crossbar (20).
12 17. Press a 3/4Ó Round Inner Cap (54) into each end of the three Pad T ubes (38). Press a Foam Pad (10) onto one end of a Pad T ube (38). Insert the Pad T ube into one set of holes in the bracket on the Front Leg (19). Press a Foam Pad onto the other end of the Pad T ube.
13 21. Press 25.4mm Round Inner Caps (37) into the Weight Rests (21, 66) and the Safety Spotters (63, 69). Insert the Weight Rests (21, 66) into the Uprights (1, 2). Make sure that the Weight Rests are at the same height and that the locking clips are hooked around the Uprights.
14 ADJUSTING THE FOAM P ADS The Foam Pads (10) inserted into the bracket on the Front Leg (19) can be adjusted to two different positions. T o do this, pull one Foam Pad off the Pad T ube (38). Move the Pad T ube to the other hole in the bracket on the Front Leg.
15 A TT ACHING WEIGHTS T O THE WEIGHT CARRIAGE T o use the upper or lower pulley stations, slide the desired amount of weight (not included) onto the weight tube of the Weight Carriage (47). Secure the weights with Weight Clips (50). 47 Weight T ube W ARNING: Do not place more than 150 pounds on the Weight Carriage.
Note: Ò#Ó indicates a non-illustrated part. Specifications are subject to change without notice. See the back cover of the user Õs manual for information about ordering replacement parts. Key No. Qty . Description Key No. Qty . Description Part ListÐModel No.
11 11 6 11 11 13 17 60 68 33 25 38 10 54 54 39 31 45 35 40 34 11 6 31 34 11 6 31 11 6 11 6 67 6 67 6 11 6 45 55 11 57 11 35 62 35 62 56 56 12 69 37 32 47 12 61 61 61 61 35 35 6 67 6 67 11 6 17 16 71 3.
Part No. 157727 R0999A Printed in China © 1999 ICON Health & Fitness, Inc. T o order replacement parts, simply call our Customer Service Department toll-free at 1-800-999-3756, Monday through Friday , 6 a.m. until 6 p.m. Mountain T ime (excluding holidays).
Een belangrijk punt na aankoop van elk apparaat Image IE40890 (of zelfs voordat je het koopt) is om de handleiding te lezen. Dit moeten wij doen vanwege een paar simpele redenen:
Als u nog geen Image IE40890 heb gekocht dan nu is een goed moment om kennis te maken met de basisgegevens van het product. Eerst kijk dan naar de eerste pagina\'s van de handleiding, die je hierboven vindt. Je moet daar de belangrijkste technische gegevens Image IE40890 vinden. Op dit manier kan je controleren of het apparaat aan jouw behoeften voldoet. Op de volgende pagina's van de handleiding Image IE40890 leer je over alle kenmerken van het product en krijg je informatie over de werking. De informatie die je over Image IE40890 krijgt, zal je zeker helpen om een besluit over de aankoop te nemen.
In een situatie waarin je al een beziter van Image IE40890 bent, maar toch heb je de instructies niet gelezen, moet je het doen voor de hierboven beschreven redenen. Je zult dan weten of je goed de alle beschikbare functies heb gebruikt, en of je fouten heb gemaakt die het leven van de Image IE40890 kunnen verkorten.
Maar de belangrijkste taak van de handleiding is om de gebruiker bij het oplossen van problemen te helpen met Image IE40890 . Bijna altijd, zal je daar het vinden Troubleshooting met de meest voorkomende storingen en defecten #MANUAl# samen met de instructies over hun opplosinge. Zelfs als je zelf niet kan om het probleem op te lossen, zal de instructie je de weg wijzen naar verdere andere procedure, bijv. door contact met de klantenservice of het dichtstbijzijnde servicecentrum.
